Concrete Space Frame Applied to an Arctic M.O.D.U.
The BOUYGUES experience in the use of concrete space frame technology for civil works and the application of this technique, combined with high strength concrete and prefabrication, to...
Use of Rayleigh Waves in Liquefaction Studies
The Spectral-Analysis-of-Surface-Waves method is a new seismic method for efficient determination of shear wave velocity in situ. Vertical impacts applied to the ground surface are used...
Behavior of Drilled Piers in Layered Soils on Texas Barrier Islands
Twenty-eight full scale load tests and the results of 41 geotechnical studies were analyzed to correlate shear strength interpreted from field and laboratory test data with those derived...
Landslide Hazard Rating for the Oregon Coast Range
The landslide hazard rating system for shallow soils on steep terrain over hard sandstone has three components: ground water response to precipitation, soil shear strength (including root...
Abutment Seepage at Smithville Dam
After initial filling there was concern for the stability of Smithville Dam when higher than anticipated piezometric levels were experienced in the left abutment foundation. Concern heightened...
Permanence of Chemically Grouted Sands
Test specimens were prepared with one of three uniformly graded sands of a fine gravel and injected with one of five silicate or two polyacrylic grouts. The polyacrylic grouts showed no...
An Application of Probability to Rock Slope Design
This paper describes the use of probability and statistics in the slope design process. An example is presented of a high rock slope in an open pit mine. This slope is a major concern...
Bond Check for Concrete-Filled Steel Tubular Columns
In order that a concrete-filled steel tubular column may display a maximum bearing capacity for sustaining the long-term vertical loads transferred from the steel beams to the steel tube...
Beam to Column Stress Transfer in Composite Structures
To clarify the mechanism of the stress transfer from the steel beam to the composite column through the beam-column joint, eight exterior beam column assemblies were tested under reversed...
Shear Strengths of Concrete-Filled Steel Box Elements
This study evaluated the ultimate strengths as well as the effect of the ultimate composite actions of concrete-filled steel composites under combined bending, shear, and axial forces....
Seismic Capacity Evaluation of SRC Buildings
The Japanese standard for seismic capacity evaluation of existing composite steel and reinforced concrete (SRC) buildings was introduced. As it developed, based on the previously established...
High Strength Steel
A
Numerical Simulation of Soil-Pipeline Interaction in a Ground Subsidence Zone
In this paper, the flexural interaction between a buried pipeline and the surrounding soil is examined by employing a combined boundary element-finite element scheme. The flexural interaction...
Long Term Testing of Centrifugally Cast Glass Fibre Reinforced Plastic Pipes (RIRP)
The paper discusses testing of pipe manufactured by centrifugal molding. The tests included external load tests, internal load, hydrostatic internal pressure, and cyclic internal pressure....
KEMCOR?A Chemical and Corrosion Resistant Piping System
KEMCOR is a new underground composite pipe system designed for chemical process use in such industries which require a high degree of corrosion resistance to varying concentrations and...
Behaviour and Strength of Steel Frames with Semi-Rigid Connections
A research study was started at the Politecnico of Milan (Italy) to investigate the influence of the main governing parameters on the behaviour and strength of flexible frames. A sophisticated...
Shear Design of Masonry Walls
The paper presents a summary of a research project carried out at the Swiss Federal Institute of Technology Zurich to develop a design method based on the ultimate strength of masonry...
Load-Bearing Capacity of Masonry Walls in a Critical Buckling Condition Taking Into Account the Restraining Effect of Floor Slabs
This paper studies the buckling effect of masonry walls and concrete floor slabs as a frame system. The frame is calculated according to the theory of II. order. The buckling length, the...
Wall/Floor-Slab Interaction in Brickwork Structures
The paper summarises the results of three series of tests on sections of brickwork structure carried out with a view to determining the characteristics of wall/floor slab joints in terms...
Type C Fly Ash and Clay Stabilization
Because the soils onsite have a high swell potential, a 37 foot high retaining wall was designed with counterforts and was supported by pier foundations to limestone. In order to reduce...
Return to search