Nonlinear Dynamic Response of Framed Structures Using the Mode Superposition Method
This paper describes a methodology for nonlinear dynamic response analysis of framed structures using the mode superposition method. A portal frame example is presented and compared to...

Free Vibration Analysis of Asymmetric Buildings
A simple procedure for free vibration analysis of asymmetric buildings is presented. This method assumes that each floor is a rigid diaphragm with three degrees of freedom (two lateral...

Wave Induced Vortex Near Seashore
The vortex motion behind submerged breakwaters in the nearshore region is studied. The RCPWAVE model (Ebersole et al., 1986) is used to calculate the wave field and thus the radiator stresses...

The Transverse Vortex in the Wall Regions of the Turbulent Boundary Layers in the Flows with Adverse Pressure Gradient
The vortical structures in the turbulent boundary layers in the flow with adverse pressure gradient were investigated by the hydrogen bubble technique. The vortices were visualized in...

Functional Analysis in Continuum and Structural Mechanics
Following brief historical remarks, the equations of the hypercircle and hypersphere of Prager and Synge and associated formulae for pointwise bounds are derived. The application of the...

Steady-State Nonlinear Heat Transfer in Multilayered Composite Panels
A two-dimensional computational model is developed for the nonlinear heat transfer in multilayered composite panels. The model is based on a first-order thermal lamination theory with...

Probabilistic Assessment of Composite Structures
Formal procedures are described which are used to computationally simulate the probabilistic behavior of composite structures. The computational simulation starts with the uncertainties...

Nonlinear Geometric and Material Considerations in Shell Structures
A geometrically and materially nonlinear static shell theory allowing large displacements, rotations, and strains with parabolic shear is developed. The theory is cast into a total Lagrangian...

A Shear Locking Free Three-Node Triangular Plate Bending Element for Moderately-Thick and Thin Symmetrically Cross-Ply Laminated Plates
A shear locking free three-node triangular plate bending element based on Reissner/Mindlin theory for symmetric general cross-ply laminated plates is developed. The element has total nine...

First-Passage Failure Predictions for Yielding Primary-Secondary Systems
Approximate methods are used to investigate the effect of nonnormality (non-Gaussianity) on the time of first-passage failure for a linear secondary system mounted on a yielding primary...

First Order Importance Sampling Method and its Variance Reduction
This paper proposes an Importance Sampling method for structural system reliability problems with linearized modal failure surfaces. It has the advantage of locating all samples in the...

Response of Mono-Coupled Distributed Parameter Systems to Random Excitation
The random vibration of periodic structures consisting of a multiplicity of closely coupled distributed parameter substructures is addressed. The problem formulation is general, and the...

Interaction Between Soil and a Rigid Foundation in a Layered Medium: A New Analytical Approach
This paper is concerned with derivation of the impedance matrix for the problem of interaction between soil and an embedded rigid foundation in a layered medium. As an approximation, the...

Dynamic Response Analysis of Pile Foundations by Using Variational Calculus
Various approaches have been developed for the frequency-domain dynamic response analysis. The one proposed by M. Novak (1974) is simplest of all and yet produces the results very close...

Flexible Plates for Control of Stress Distribution
Use of a flexible plate in minimization of soil reaction concentrations at the edge was analyzed. The analysis utilizes a solution for vertical vibrations of the circular flexible plate...

Experimental and Theoretical Dynamic Compliances of Foundations
An experimental study of the dynamic behavior of surface foundations on granular soils by centrifuge modeling is presented. The test method allows a direct measurement of the complex-valued...

Retrospect and Prospect: Micromechanics
In the mechanics community the term micromechanics is often used to identify scientific efforts in which certain overall macroscopic material response and failure modes are characterized...

Wave Propagation in Solids
The last fifty years have seen the development of a large number of application of the theory of wave propagation in solids to problems of interest to civil engineers. Most notable have...

Postbuckling Behavior of Stiffened Composite Shell Panels
The paper summarizes the current status of an ongoing study on the postbuckling behavior of thick and moderately thick composite stiffened shells. Axially compressed moderately thick panels...

Dynamic Stability of Composite-Material Circular Cylindrical Shells with Orthogonal Stiffeners
The governing equations are formulated for general (axisymmetric or unsymmetric) vibrations of thin circular cylindrical shells of composite material and reinforced with axial (stringer)...

 

 

 

 

Return to search