ASCE will be sunsetting the Civil Engineering Database (CEDB) in the coming months. We encourage you to start using the ASCE Library to perform content searches. In the ASCE Library, you can save your search results as well as receive email content alerts when new content relevant to your area of interest is published. Try it out today at https://ascelibrary.org.

 

Free Vibration Analysis of Asymmetric Buildings
A simple procedure for free vibration analysis of asymmetric buildings is presented. This method assumes that each floor is a rigid diaphragm with three degrees of freedom (two lateral...

Wave Induced Vortex Near Seashore
The vortex motion behind submerged breakwaters in the nearshore region is studied. The RCPWAVE model (Ebersole et al., 1986) is used to calculate the wave field and thus the radiator stresses...

The Flow in the Front Stagnation Region of a Square Plate with a Small Disturbing Wire in its Upstream
The flow in the front stagnation region of a square plate was investigated experimentally in a water channel. A small wire was placed in the upstream of the square plate to create a small...

The Transverse Vortex in the Wall Regions of the Turbulent Boundary Layers in the Flows with Adverse Pressure Gradient
The vortical structures in the turbulent boundary layers in the flow with adverse pressure gradient were investigated by the hydrogen bubble technique. The vortices were visualized in...

Vortex Suppression in Wet-Pit Pump Intakes
Two distinct examples to suppress both air-entraining and boundary-attached subsurface vortices in large vertical pump intakes are presented that were developed by means of hydraulic model...

Complementary Potentials of Finite Elasticity
The principles of virtual displacements and forces are embodied in a functional P. The complementary potential P_c is defined by the equation; P_c...

Mechanics of Growing Deformable Solids: A Review
An attempt is undertaken to summarize the contemporary knowledge in mechanics of deformable solids of accruing mass. A general mathematical model of an abstract growing deformable solid...

Functional Analysis in Continuum and Structural Mechanics
Following brief historical remarks, the equations of the hypercircle and hypersphere of Prager and Synge and associated formulae for pointwise bounds are derived. The application of the...

Estimating Damage and its Influence on Fracture Toughness
To estimate damage in a quantitative manner, a technique used whereby six values of linear strain are measured on a material element as a function of hydrostatic pressure. The high precision...

Steady-State Nonlinear Heat Transfer in Multilayered Composite Panels
A two-dimensional computational model is developed for the nonlinear heat transfer in multilayered composite panels. The model is based on a first-order thermal lamination theory with...

Probabilistic Assessment of Composite Structures
Formal procedures are described which are used to computationally simulate the probabilistic behavior of composite structures. The computational simulation starts with the uncertainties...

Nonlinear Geometric and Material Considerations in Shell Structures
A geometrically and materially nonlinear static shell theory allowing large displacements, rotations, and strains with parabolic shear is developed. The theory is cast into a total Lagrangian...

A Shear Locking Free Three-Node Triangular Plate Bending Element for Moderately-Thick and Thin Symmetrically Cross-Ply Laminated Plates
A shear locking free three-node triangular plate bending element based on Reissner/Mindlin theory for symmetric general cross-ply laminated plates is developed. The element has total nine...

First-Passage Failure Predictions for Yielding Primary-Secondary Systems
Approximate methods are used to investigate the effect of nonnormality (non-Gaussianity) on the time of first-passage failure for a linear secondary system mounted on a yielding primary...

First Order Importance Sampling Method and its Variance Reduction
This paper proposes an Importance Sampling method for structural system reliability problems with linearized modal failure surfaces. It has the advantage of locating all samples in the...

Response of Mono-Coupled Distributed Parameter Systems to Random Excitation
The random vibration of periodic structures consisting of a multiplicity of closely coupled distributed parameter substructures is addressed. The problem formulation is general, and the...

Interaction Between Soil and a Rigid Foundation in a Layered Medium: A New Analytical Approach
This paper is concerned with derivation of the impedance matrix for the problem of interaction between soil and an embedded rigid foundation in a layered medium. As an approximation, the...

Dynamic Response Analysis of Pile Foundations by Using Variational Calculus
Various approaches have been developed for the frequency-domain dynamic response analysis. The one proposed by M. Novak (1974) is simplest of all and yet produces the results very close...

Flexible Plates for Control of Stress Distribution
Use of a flexible plate in minimization of soil reaction concentrations at the edge was analyzed. The analysis utilizes a solution for vertical vibrations of the circular flexible plate...

Experimental and Theoretical Dynamic Compliances of Foundations
An experimental study of the dynamic behavior of surface foundations on granular soils by centrifuge modeling is presented. The test method allows a direct measurement of the complex-valued...

 

 

 

 

Return to search