Design, Construction, and Maintenance of Relief Wells
Technical Engineering and Design Guides, as adapted from the U.S. Army Corps of Engineers, No. 3 This engineering manual provides guidance and information...

Boston's Backup Water Supply
For fifty years, Boston's sole real source of water has been the Hultman Aqueduct, but now final design is almost complete on the MetroWest Supply Tunnel, a new, larger conduit...

An Experimental and Analytical Study of the Shoreline Response to Non-Parallel Breakwaters in Oblique Waves
REsults of an experimental and analysis study single breakwaters on oblique waves are presented. Three orientations of the breakwaters are studied, those being parallel to the shoreline,...

Wave Run-Up and Reflection on a Permeable Sea Wall
The swash oscillation on a sloping seawall made of step-shaped concrete blocks, waves and water particle velocity in front of the seawall were measured. It was inferred that incident waves...

Wave Transformation and Load Reduction Using a Small Tandem Reef Breakwater ? Physical Model Tests
The performance of several small reef breakwaters, and a tandem breakwater system (consisting of a reef breakwater positioned upwave from a surface-piercing main breakwater), are quantified...

The Evolution of Breakwater Design
The purpose of this paper is to present a view of the evolution of both the rubble mound and vertical faced breakwaters from the earliest design through the Iribarren and Hudson era. Determining...

Dynamic Loading of Airfield Pavements Caused by Aircraft Operations on Rough Runways
This paper presents results for dynamic pavement loading of various aircraft under takeoff and taxing scenarios. The data were obtained from computer simulation and applied to the Corps...

Implementation of Elastic Layered Theory for Design of Unbonded Overlays
The U.S. Army and Air Force have implemented the elastic layered theory for design of unbonded overlays for rigid airfield pavements. The procedure allows for design of unbonded overlays...

Joint Probability Distribution of Rainfall Intensity and Duration
Intensity-duration-frequency (IDF) curves are widely used for peak discharge estimation in designing hydraulic structures. Accurate interpolated and extrapolated intensity values are difficult...

Integration of Reliability, Uncertainty and Optimization in Hydraulics Systems: Structural Reliability
The focus of this paper is to provide an overview of analysis and optimal design of systems in which the system reliability is dependent upon the structure of the system (such as the layout...

Reliability Analysis of a Multi-Reservoir Water Distribution System
A methodology for evaluating system reliability is developed to assist in the planning and management of a multi-reservoir water distribution system. The minimum cut-set approach is employed...

Concrete Watertight Structures and Hazardous Liquid Containment
The purpose of Concrete Watertight Structures and Hazardous Liquid Containment is to provide a practical guide for practicing engineers who...

Engineering, Construction, and Operations in Space IV
This proceedings, Engineering, Construction and Operations in Space IV, consists of over 155 papers presented at Space 94, the Fourth International...

Success Syndrome: The Collapse of the Dee Bridge
Scaling up existing successful designs can cause latent weaknesses to become dominant, leading to catastrophe. By studying past failures where this has happened--for example, the 1847...

Road to Recovery
The effect of the Loma Prieta earthquake on San Francisco's elevated viaduct system is still being felt more than four years later. Immediately after the quake, the entire...

Coastal Groins and Nearshore Breakwaters
Technical Engineering and Design Guides, as adapted from the U.S. Army Corps of Engineers No. 6. This book provides guidance for the design and placement...

Roller Compacted Concrete IV
This engineering manual Roller-Compacted Concrete from the U.S. Army Corps of Engineers provides information and guidance on the use of roller-compacted...

Retaining and Flood Walls
The engineering manual Retaining and Flood Walls from the U.S. Army Corps of Engineers provides guidance for the safe design and economical...

Modular Evolution
The construction industry typically thinks of modular steel bridges in terms of the World War II vintage Bailey Bridge. The Bailey Bridge was designed to be quickly deployed to replace...

Solar Stretch
Extrapolating from structural work with textile or metal membrane roofs to cover silos, assembly halls and sports stadia, Schlaich, Bergermann and Partners, a structural engineering firm...

 

 

 

 

Return to search