Annual and Seasonal Variations of Phosphorus Loads in the Okanagan River
Results of monitoring of phosphorus loads in the Okanagan River channel linking Okanagan, Skaha and Osoyoos Lakes are described. The southern Okanagan basin is the area where major changes...

Effect of Shallow Trench Construction on Cast Iron Pipelines
This paper summarizes the results of three-dimensional finite element analyses to evaluate the strains and displacements sustained by 4, 6, and 8-in. (100, 150, and 200 mm)-diameter cast...

Stiffness Requirements for HDPE, Profile Wall Pipe
For the past two years the Gulf Oil Corporation has sponsored a research study on profile wall High Density Polyethylene (HDPE) pipe at Texas A & M University. A pipe design computer...

The Relative Strain as a Design Criterion for Buried uPVC Gravity Sewer Pipes
When designing buried plastic sewer pipes, the relative strain caused by deflection of the circular pipe section is of particular interest. The reason for increased interest is the present...

Strains Induced by Combined Loading in Buried Pressurized Fiberglass Pipe
In 1983 Owens Corning Fiberglas and Utah State University collaborated on a study of combined strain behavior of fiberglass pipe to quantify the bending strain reduction as a function...

Stress and Strain Responses of a Soil-Pipe System to Vehicular Traffic
A 16-in. natural gas pipeline near Racine, Wisconsin, had been in service for some 30 years. In 1982 road widening operations on a line parallel with the pipe presented the opportunity...

Field Testing of 84-Inch-Diameter Plastic Pipe
During the summer of 1981, a research project was initiated to monitor strains and deformation in 84-inch diameter RPM (reinforced plastic mortar) pressure pipe. Three 20-foot (6. 1-m)...

Design of Non-Pressure Very Flexible Plastic Pipe
There is considerable debate about the correct structural design procedure to be used for very flexible plastic pipe (VFP) - typically glass-fiber reinforced pipe (GRP), reinforced plastic...

Comparing Flood Stage-Discharge Data?Be Careful!
A long term stage-discharge record is extremely valuable data. However, simplified applications of long term records to draw sweeping conclusions about man's effects should be avoided,...

Girth Weld Defect Tolerance Criteria
This paper describes the following criteria proposed for setting allowable defect sizes in girth welds: PD 6493:1980, 'Guidance on Some Methods for the Derivation of Acceptance...

Time-Dependent Damage and Creep of Brittle Rock
In this paper, some results of a combined analytical-experimental study of the relationship between subcritical microcrack growth due to stress corrosion and the time-dependent deformation...

Continuum Modeling of Discrete Structures with Geometric Nonlinearities
The modeling of geometrically non-linear discrete structures by an equivalent continuum is presented. The discrete-continuum analogy is developed by first isolating a unit cell of the...

Small Strain Measurements Using Triaxial Apparatus
This paper presents a detailed testing methodology which can be used to determine the cyclic properties of soils at very small strains using triaxial apparatus. A discussion of specific...

Libby Rereg's Combined Spillway and Powerhouse
The existing powerhouse at Libby Dam, located near Libby, Montana has four generating units for a total of 420 MW. Provisions have been made which will allow doubling the plant rating...

A Study of Deformations in Concrete Faced Rockfill Dams
This paper presents the results of studies on the behavior of certain concrete faced rockfill dams (CFRD), which were conducted during the Basic Design of Machadinho dam in Brazil. The...

Rating Pavements by Computer
Pavement rating is a necessary and labor-intensive job and one with a high turnover rate of personnel. Also, rating scores are often inconsistent from day to day, or between different...

Tension Tests of Containment Wall Isolated Liner Plates
Two tests were conducted using an approximate 2:1 ratio of hoop to meridional load. This simple load ratio is a gross approximation of the liner plate loading in a containment subjected...

Structural Performance Predictions for Liner Plates on Nuclear Facilities
The history of the use of liner plates is presented. It is shown that the liner plate can be buckled, and can be bonded or not bonded to the concrete. The buckled plate usually has bending...

Design Criteria for Buried Flexible Pipe
A modified CANDE program was used to analyze a full factorial set of design parameters for buried, large diameter high density polyethylene profile-wall pipe. A new pipe subroutine was...

Easing Strains in Partner-Managed Firms
The family-like nature of partnerships promotes shared management responsibilities but creates conflict. Partnerships, like families, are often taken for granted by the partners. Nonpartners...

 

 

 

 

Return to search