Integrated Automatic Hydroelectric Plant Control
The increased acceptance and employment of microcomputers to control specific functions in small hydroelectric plants has led to computerized integrated total control of hydropower generation....
Accelerated Life Testing of Generator Coils
This paper presents a step-by-step procedure for doing a 400 hour, 60 Hz, 90 degree C accelerated life test on generator coils. Test procedure is as follows: 1. Initial coil examination...
Upriver Dam Hydroelectric Project Rehabilitation After Failure, Part A: Failure Investigation and Lessons to be Learned
A lightning strike caused electrical failure at Spokane's two Upriver power plants, resulting in the river overtopping Project embankments, and causing nearly 11. 5 million...
Pyrites Hydroelectric Project, Canton, New York
This paper describes the Pyrites Hydroelectric Project in Canton, New York, an 8-MW project completed in December 1985. The key to its successful development was a team approach that included...
Landmarks in Civil Engineering
Historic American engineering projects sampled in this article represent those documented in
Sewage Plant Engineered for Value
The Camden County (NJ) Municipal Utilities Authority was formed in 1972 to cope with suburban growth that had overloaded 34 primary treatment plants. By the early 1990s, the Authority...
Geotechnical Exploration and Site Preparation Techniques for Large Mall in Karst Terrain
A large commercial mall and secondary developments were planned for construction in a karst area near Clarksville, Tennessee. A geotechnical exploration was conducted to evaluate the occurence...
Treatment of Karst Along Tennessee Highways
The construction and maintenance of highways in karst areas of East Tennessee has resulted in the occurrence and treatment of induced sinkholes along the ditchlines of numerous highways....
Parallel Algorithms for Structural Optimization Under Dynamic Loading
Parallel algorithms and strategies are outlined for optimal design of frame structures subjected to dynamic earthquake loading. Parallelism is extracted in six areas: substructuring of...
Geosynthetics for Soil Improvement: A General Report and Keynote Address
The paper summarizes major developments in the field of geosynthetics since the previous symposium in 1980. The paper addresses the engineering functions of major types of geosynthetics,...
Highway Factors in Truck Wrecks
An examination is presented of highway factors as they interact with driver and vehicle factors in large truck accident causation. Examples of highway defects are discussed along with...
A Reassessment of Codified Limit States Design
This paper examines the nature of design codes and their relation to engineering practice. It suggests that codes impose unjustifiable and, in the long term, destructive constraints on...
A Probabilistic 3-D Short-Term Slope Stability Model
A probabilistic model to analyze the three-dimensional stability of earth slopes under short-term conditions is presented. An actual failure case is studied to show the implementation...
STOCAL-II-An Instructional Software for Random Vibrations
STOCAL-II (Computer Assisted Learning of STOchastic methods) is an instructional software for teaching random vibrations and applied stochastic processes. It is based on and is an extension...
A Stochastic Seismological Model in Earthquake Engineering
Recent studies of source mechanisms and wave propagation models enable one to generate strong motions based on deterministic source and source-to-site characteristics. The normal mode...
Practical Implementation of Seismic Probabilistic Risk Assessment
Many techniques for seismic probabilistic risk assessment have been developed by university researchers over the last decade. This paper reports on a study being conducted to determine...
Autoregressive Model of Spatially Propagating Earthquake Ground Motion
An autoregressive random process model was used to investigate a simulation method of spatially and temporally variative ground motion when characteristics of motion are prescribed by...
Applications of ARMA Models for Seismic Damage Prediction
As an alternative to current design practice which is based on peak measured ground motions and scaled records from different events, individual earthquake records are treated as samples...
An Expert System for Reliability Engineering
The goal in this project is to create an expert system to do failure mode investigations from 'first principles,' or the basic understanding of the way components...
Experiences with Applications of Importance Sampling in Structural Reliability Computations
This paper presents some experiences and observations relating to the use of importance sampling in structural systems reliability computations. These are presented with three examples,...
Return to search