Sediment Routing and Stream Bed Evolution Model
A one-dimensional numerical model developed by Borah, Alonso and Prasad is discussed, improved and tested. The model named STREAM routes graded sediments and simulates aggradation, degradation...
Ackers-White Equation: Transportation by Size Fractions
The Ackers-White procedure for sediment transport has been modified to permit calculation by size fractions. The original logic has been retained, but A values for incipient motion have...
The Scourge of Scour
Among 86 bridge failures from 1961 to 1976, more were caused by scour than by earthquakes, wind, structural problems, corrosion and accidents combined. Scour is the erosion of a stream...
Behaviour of Thin-Walled Channel Sections in Bending
The effects of local buckling on the behaviour and load carrying capacity of thin-walled cold formed steel plain channel sections is examined. The bending is applied in such a way that...
Anchorage Forces for Z-Purlin Supported Standing Seam Roof Systems
This paper presents the results of a limited study to determine if the provisions of Section D. 3. 2. 1 'Anchorage Bracing for Roof Systems Under Load with Top Flange Connected...
Rational Design Approach for Tension on the Net Section
A study of the bearing and net section capacities of bolt connections for material thicknesses encountered in cold-formed members was conducted. This paper summarizes the findings as they...
Stability and Limit Loads of Steel Space Trusses
An investigation of the behavior of cold-formed steel space truss structures, under the interaction of local, member, and overall buckling is described. A Finite Element computer program...
Bending Strength of Thin Cold-Formed Steel Straight Panels
An experimental investigation on the bending strength of 26 gage cold-formed corrugated steel straight panels with web-depth to thickness (h/t) ratio of 475 is presented. A typical test...
Cold-Formed Angles for Transmission Towers
Cold-formed members enable the engineer to design transmission towers that may be more cost-effective than those built with hot-rolled angles. Members can be designed to closely fit the...
Design and Test of Cold Formed Steel Members
Latticed systems represent the most spread and low-cost solution for electrical trasmission towers, when ground conditions do not affect the design choice. Steel angles have been used...
Multiple-Hearth and Fluid Bed Sludge Incinerators
This paper presents recommended practices for design and operation of multiple-hearth and fluid bed furnace systems for combustion of sludges in order to eliminate or mitigate the problems...
Response of the Citanduy River to Developments
The sinuous alluvial reach of the Citanduy River in Java, Indonesia has been surprisingly stable in spite of man-made cutoffs which have reduced the channel length from 98. 7 km to 78....
Flow and Sediment Transport in Curved Channels with Nonuniform Bed Material
Described is a scheme for controlling the exchange of grain sizes between bed and bed load in a curved alluvial channel. The scheme is an integral part of a model for simulating spatial...
A New Technique for Measuring Fine Sediment Accumulation in Gravel Bed Streams
The collection and analysis of bed material samples has been a standard practice for determining the quantity of fine sediments (less than 3. 4 mm diameter) in stream gravels. However,...
Sediment Intrusion into the Substrate of Gravel Bed Streams
A physically-based model was developed to simulate the intrusion of fine sediments into stream gravel substrates and its effects on intragravel flow. The model is capable of simulating...
Physical Habitat Simulation and the Moveable Bed
One objective of an instream flow analysis is to quantify a flow that will maintain the existing channel and/or flush fine material from the bed. Five empirical approaches to determine...
Development of the Nauvoo Point Plant Beds
In Pool 19, Mississippi River, the accumulation of sediment has resulted in soft-substrate benthic communities or macrophyte beds. Three areas in the downstream 12 miles of the 46. 3 mile...
Interactive Microcomputer Analysis and Design of Light Gage Steel Roof Systems
A hinderance to the widespread acceptance of the cold-formed steel roof Z-purlin in conventionally engineered buildings is due to the lack of a useful and efficient analysis and design...
Fluidization of Biomas Covered Sand Particles
The expansion behavior of the fluidized bed reactor support medium is important in its design and analysis. Steady state and dynamic behavior of fluidized bed expansion were compared with...
Clay Pipe Installation?Advances in Load Factors
This report presents an evaluation of traditional load factor values for clay pipe and the development of a new bedding system which gives a higher load factor. Tests demonstrate that...
Return to search