A Lateral Load Test on Seven Foot Diameter Caissons
Seven foot (2.1 m) diameter caissons (drilled shafts) were designed to support a mainline eastbound bridge and an off-ramp of Interstate Highway 70 in Glenwood Canyon, Colorado. A lateral...
Effect of Void on Footing Behavior Under Eccentric and Inclined Loads
The effect of underground void on the behavior of strip footings subjected to eccentric and inclined loads was investigated using the finite element method of analysis. Results of the...
Performance of a Large Ribbed Mat on Cohesive Soil
The performance of a 678-ft by 304-ft (207-m by 93-m) ribbed concrete mat was studied to provide improved soil input parameters for design. The mat was constructed on a low plasticity...
Environmental Economic factors of the Southern Brazilian Coast
The goal of this study is a large-scale synthesis of the ecological and economic characteristics of the Southern Brazilian Coast. The coastal area is formed by a watershed, a lagoon, and...
Coastal Zone Planning
The first objective of this methodology is to provide a feasible and practical tool to identify the potentialities of the coastal zone. The coastal environment constitutes a fragile, little...
The Coastline Between Rio De Janeiro and Cabo Frio
The coastline between Rio de Janeiro and Cabo Frio is characterized by successive long beach arcs, oriented in the East-West direction. The beaches are separated by rocky headlands resulting...
Presented in 3-D
Stone & Webster started development in 1985 on a mainframe based computer system that provides the capability to integrate all plant information into a single integrated plant...
Facilities Management With CADD
Tyson led a project that began in 1985 to develop an integrated alphanumeric and graphic database for facilities management at Stanford University. Many large institutions could benefit...
Selected Papers from Chinese Journals of Structural Engineering
This book is an initial effort to introduce selected papers from journals published by the China Civil Engineering Society to ASCE membership. The twenty papers in this volume were selected...
Structural Design, Analysis and Testing
This volume contains the papers presented in 21 sessions of the 1989 Structures Congress held in San Francisco. The papers cover a wide range of topics including types of construction...
The National PDES Testbed?An Overview
Product Data Exchange Specification (PDES) is an ambitious project with the goal of developing a standardized format for representing and exchanging information about almost any manufactured...
Graphics Interchangeability in a Heterogeneous Network
The paper outlines the complex problems of graphics interchangeability in a heterogeneous network of workstations, and discusses requirements for a practicable solution. The design of...
The Portability of Graphics Package Dependent Software
Currently at the University of Wyoming a research project is under way to investigate methods of reducing the portability problem in software design. The project entails a general functional...
Teaching Engineering with Calculation Software
The term 'calculation software' is used here to describe computer software which has the basic functionality of a programmable scientific hand calculator, but...
A Broader View of Computer Aided Design: A Novel Course Coupling Art, Communication and Engineering
A novel course is described which brings together faculty and students from Engineering, Communication and Art Departments. Students are introduced to a sophisticated computer art program,...
Project HAWK?Freshmen on PC-Based Case Studies
The paper discusses an attempt to develop a course introducing freshmen to engineering with special emphasis on engineering faculty interaction. Personal computer use, engineering cases,...
Interactive Aircraft Section Calculations for Drag
Large interactive computer programs are being called upon with increasing frequency for the preliminary and conceptual design of aircraft. One drag component which can be estimated at...
Real-Time and Off-Line Aids for Teaching Digital Control
This is a report of unique computer tools developed for teaching of the design of digital control systems at the University of Wyoming. The real-time components of the laboratory involve...
Stereolithography
Stereolithography is a three-dimensional printing process which produces accurate copies of CAD solid or surface models directly from CAD data. The process uses a moving laser beam, directed...
LAN Implementation in a Teaching Laboratory for Computer Integrated Manufacturing
The CIM (Computer Integrated Manufacturing) lab at Western Washington University contains a miniature factory with five robotic workcells and eight computers representing various departments...
Return to search