Well and Formation Losses
For design projects in the groundwater area, a step-drawdown test is commonly used to investigate the properties of the well-aquifer systems. Higher well and formation losses are usually...
Aquifer Measurements at Different Scales
Multilevel slug test data from five wells in a confined, sandy aquifer were analyzed to obtain an estimate of the vertical variation of the horizontal hydraulic conductivity, K(z). Hydraulic...
Transport Models to Simulate Nitrate Contamination
Computer models can be used to simulate groundwater flow and contaminant transport in the vadose zone, the results of which can be used as input to simulate flow and transport in the saturated...
On the Application of Multiphase Flow Models for the Simulation of Density Stratified Flow in Aquifers
Two types of numerical simulation approach are usually applied when simulating density-stratified flow in aquifers: (a) the sharp interface approach, and (b) the coupling of flow transport...
Visualization Studies of Dense Leachate Plumes in Porous Media
In this paper, a series of flow visualization experiments investigating the behavior of dense leachate plumes are described. These experiments were performed in various flow containers...
Concentration Measurements in Dense Leachate Plumes Using a Gamma Radiation System
An automated, nonintrusive technique is discussed that determines salt concentrations in dense leachate plumes. The dense plumes were introduced from a line source into a relatively narrow...
Effect of Nile River Flow on Performance of Shoubrah Power Plant Cooling System
Shoubrah El-Khimah Power Plant was built in 1982. Its peak capacity is 1200 MW, generated by four units, three of them having one cooling water intake. The cooling water pumps suffer from...
Bed Forms of Nile River
In this paper, the observed bed forms for six different reaches of the Nile River in Egypt are described. The purpose of the study is to inquire whether or not the different available...
Application of Stable Channel Design Method
Systematic stable channel design methods are currently being developed by the US Army Engineer Waterways Experiment Station for use in the planning stages of local flood control projects....
Bed Load Roughness in Supercritical Flow
A supercritical concrete channel is proposed for Mission Creek located in Santa Barbara County, California. The proposed channel may transport gravels and cobbles as bed load during large...
Operational Procedures for Estimating Bottom Exchange Rates
After briefly reviewing the terminology of the various bottom and water column exchange fluxes, the body of this paper summarizes five possible procedures for establishing operational...
Standardization of Culvert Flow Computations
Culvert flow computations are generally computed by the Federal Highway Administration's (FHWA) nemographs or its HY8 computer program, the U.S. Army Corps of Engineers'...
Stepped Spillway Design for Flow Over Embankments
Many embankment dams have been identified as unable to pass their design flows without failure due to overtopping. The U.S. Bureau of Reclamation (Reclamation) is currently at the forefront...
Three-Dimensional Velocity Distribution at Open-Channel Diversions
A study is underway to develop an improved understanding of the 3-D flow pattern at 90? diversions. The main goal is to explain, via the velocity distribution, the behavior of sediment...
Fluidization Pipe Hole Spacing
Two-dimensional fluidization experiments are performed on fine (d50 = 0.15 mm) and medium coarse (d50 = 0.45...
A Review of Sediment-Water Column Process Modeling and Future Applications in Waste Load Allocation
The capabilities of empirical modeling techniques are discussed and three promising mechanistic models to simulate sediment-water interactions are reviewed with respect to their possible...
Modeling and Field Experiments for Tracer Gas Tests
Numerical modeling and field experiments were used to extend the tracer gas technique for determining surface gas transfer rates to shallow bays. Two-dimensional modeling was used to investigate...
Field Verification of Diffuser Performance
Effluent diffusers are used to gain relief from end-of-pipe acute toxicity criteria in NPDES water quality-based discharge permitting. Regulatory agencies require that the dilution provided...
Finite Element Modeling of Flow in Wetlands
Requirements for developing a mathematical model of unsteady flow in wetlands are suggested. An equivalent continuum approximation is appropriate to avoid problems of describing the turbulence...
TABS-2 Application to Kawainui Marsh Flood Control
The TABS-2 mathematical modeling system was used to evaluate the effectiveness of alternatives designed to eliminate flooding problems in the Kawainui Marsh located in Kailua on the east...
Return to search