Hydraulic Model Studies?Pak Mun Hydroelectric Project (Thailand)
The paper presents briefly the hydraulic problems related to the project which were successfully solved by the 1 to 100 scale hydraulic model study carried out at the Asian Institute of...
Modernization of Hydroturbines?New Approach to Effectiveness, Reliability, Environment
Renovation of hydraulic turbines is one of the major lines in LMZ production and is aimed at rehabilitation of hydroturbines and increasing efficiency, rated output and energy production....
Direct Load Cell-Based Weighing Lysimeter System
A low-cost weighing lysimeter system is described which is capable of measuring evapotranspiration with an accuracy of 0.05-0.10 mm. A two-lysimeter system with electronic data logger...
Accuracies of Lysimeter Data Acquisition Systems
Electronic dataloggers are integral parts of most weighing lysimeter systems. Dataloggers supply excitation voltages to lysimeter load cells and measure resulting voltage signals. Resolution...
Water and Salt Movement Under Trickle Irrigation
Experiments have been conducted to study the effect of the drip irrigation parameters on the movement of water and salt in the trickle wetted soil volume. The study indicated that for...
Estimation of Loading via Fingered Flow
Results of experimental investigations of fingered preferential flow are combined into a concise, conservative engineering methodology for predicting pollutant transport through fingered...
Source of Atrazine and Desethylatrazine in a River, During Base Flow
A budget of atrazine and desethylatrazine loads was computed for a 116-kilometer reach of the Cedar River in Iowa to determine where these compounds enter the river during base-flow conditions....
Bed Forms of Nile River
In this paper, the observed bed forms for six different reaches of the Nile River in Egypt are described. The purpose of the study is to inquire whether or not the different available...
Sediment Transport Measurements in the Nile River at Bani Mazar
Measurements of sediment transport on the Nile River were conducted at Bani Mazar (200 km South of Cairo) during high and low water stages. Bed-load and suspended-load transport rates...
Movable-Bed Model to Evaluate Nile River Dredging
About 200 km south of Cario, at Bani Mazar reach, the Nile River has widened and formed several islands. The result is three channels with shallow depths. One of the branches must be improved...
Hydraulic Aspects of Grade Control Structures
This paper describes the function of grade control structures. The primary purpose of a grade control structure is to maintain or establish a desired bed elevation in a channel. Basically...
Bed Load Roughness in Supercritical Flow
A supercritical concrete channel is proposed for Mission Creek located in Santa Barbara County, California. The proposed channel may transport gravels and cobbles as bed load during large...
Operational Procedures for Estimating Bottom Exchange Rates
After briefly reviewing the terminology of the various bottom and water column exchange fluxes, the body of this paper summarizes five possible procedures for establishing operational...
Design of Groins on the Middle Rio Grande
The Albuquerque Projects Office of the Bureau of Reclamation wanted to use groins in place of revetments at two sites on the Rio Grande. The Bureau of Reclamation has limited experience...
A Review of Sediment-Water Column Process Modeling and Future Applications in Waste Load Allocation
The capabilities of empirical modeling techniques are discussed and three promising mechanistic models to simulate sediment-water interactions are reviewed with respect to their possible...
Incipient Motion Criteria Defining Safe Zones for Salmon Spawning Habitat
Approximately 70% of the City of Seattle's water supply is drawn from the Cedar River. Between 200,000 and 400,000 sockeye salmon spawn annually in this partially dewatered...
Enhancing Effluent Water Quality of Sedimentation Basins Using Constructed Wetlands Technology
The Tennessee Valley Authority (TVA) has constructed twelve wetlands to treat acid drainage at reclaimed coal mines and fossil-fueled power plants. These wetlands are designed primarily...
A Study of Friction Factor for Flow in Gravel Bed Channels
For many years practicing engineers have faced the problem of predicting the resistance to flow in channels with rough surface. Flow in channel is a complex interaction between surface...
Calibration of Beni-Mazar Movable Bed Model
A sand-bed model representing a reach of the Nile River was constructed to study alternative solutions to maintaining the navigation channel. Flume tests were carried out first to determine...
Safety Analysis of Handset Wood Slab Formworks
A reliability index is calculated for flexural strength of a handset wood slab formwork system. Load and resistance models are based on a survey of construction loads and wood test data...
Return to search