Regulatory Floodway Width Estimation
A simple algebraic equation is presented for determining the width of the regulatory or designated floodway. The equation shows that for a given ratio of the permissible increase in flood...
On the Selection of Sediment Transport Equations
Existing sediment transport relationships have been calibrated under a certain range of experimental conditions which can be described by the dimensionless grain size, the mobility number,...
Effect of Streamflow Conditions on Gas-Transfer Coefficients
Contrary to the findings of previous studies of channel-controlled stream reaches, it was found that, in four reaches of a small stream characterized by a series of pools and riffles,...
Loss of Aquatic Habitat in Quincy Bay
Quincy Bay is a backwater area along the upper Mississippi River near Quincy, Illinois. The construction in 1969 of a small boat access channel about 3. 2 km upstream of the natural bay...
Response of a Lake Outlet Channel to Dredging
Channel improvements were completed in 1982 along approximately 8 miles of the Little Tallahatchie River just downstream of Sardis Dam. Heavy rains shortly after completion of the improvement...
Development of a Monitoring Program and Vegetative Restoration Project in a Mississippi River Bendway
The Dry Bayou-Thompson Bend area is located on the right descending bank of the Mississippi River between river miles 4. 5 (7. 2 kilometers) and 30. 0 (48. 3 kilometers) above the confluence...
Modification of Meander Pattern Using Wing Dams
A sharp river bend and a highway bridge together create potentially hazardous conditions for all down-bound barge tows on the Mississippi River at Lansing, Iowa. The tendency of the river...
Stream Width Adjustment to Upstream Loading
Channel width adjustments takes place either by fluvial erosion or accretion of the banks, or by their mass failure under gravity and subsequent removal of the slump debris. Simulation...
Sediment Routing and Stream Bed Evolution Model
A one-dimensional numerical model developed by Borah, Alonso and Prasad is discussed, improved and tested. The model named STREAM routes graded sediments and simulates aggradation, degradation...
Red River Pilot Channel Design and Development
This paper presents the design parameters for two pilot channels constructed on the Red River. The factors often associated with the development of pilot channels are identified in an...
Roughness Coefficients of Large Floods
Most hydraulic calculations of flow in channels and overbank areas require an evaluation of flow resistance generally expressed as Manning's roughness coefficient, n. Literature...
Water Rights Considerations Associated With Channel Conveyance Losses
During 1986, the Wyoming Water Research Center and the State Engineer's Office cooperatively did a study on the conveyance losses associated with a section of stream channel...
Estimating Number and Duration of On-Times for Surge Irrigation
Research shows surge flow can achieve efficient and uniform irrigation on some soils. However, most available information focuses on computerized analysis and modeling for research purposes....
Theoretical Flow Model for Drop Structures
A theoretical model based on the momentum equation is reviewed for a trapezoidal weir drop structure operating in a trapezoidal channel. Preliminary qualitative results indicate agreement...
Application of the New SCS Time of Concentration Method
The second edition of the Soil Conservation Service (SCS) TR-55, published in June 1986, introduces a new method for calculating the time of concentration for storm runoff flowing through...
USDA-Water Erosion Prediction Project (WEPP)
The USDA-Water Erosion Prediction Project (WEPP) will develop improved erosion prediction technology based on modern hydrologic and erosion science that will be process-oriented and conceptually...
General Considerations for Seismic Stability
The basic design consideration is provision of sufficient stiffness, strength and adequate ductility for the varied loads imposed on the building. Adequate stiffness is needed to resist...
Comparison of the Third and Fourth Edition of the Guide: What is New and Different
The fourth edition of the 'Guide to Stability Design Criteria for Metal Structures' is a unique collection of ideas and information on stability problems. It...
Centrally Loaded Columns
The paper has given a detailed description of the chapter on centrally loaded columns that will appear in the 4th Edition of the Structural Stability Research Council 'Guide...
Frame Stability
The Chapter on Frame Stability of the Fourth Edition of the SSRC Guide provides guidance on use of several stability design procedures. These include Critical Load Concept, Second-Order...
Return to search