Seismic Design of Cable-Stayed Bridges: Evaluation and Research Needs
Earthquake-response characteristics of cable-stayed bridge are evaluated. 2-D and 3-D models are considered. The cases of multiple-support and uniform excitations are considered; furthermore,...
Current Bridge Research at Iowa State University
For the past 20 years the majority of the structural engineering faculty in the Department of Civil and Construction Engineering at Iowa State University (ISU) have performed research...
Some Design Considerations During Construction
Certain construction failures are discussed with associated design conditions leading to these failures. Some points of interest for engineers involved with construction equipment designs...
Impact of Errors on Safety During Construction
The construction process involves a number of procedures which integrate together from the first intention of building the project to the end of the structural cycle. In this study, a...
Heath Building?Load Paths of an Underpinning
A case study of an underpinning is presented which, in principle, consists of the introduction of a transfer system in an existing building. The transfer system modifies the load paths...
Codified Reliability for Structures During Construction
It is generally acknowledged that the most critical stage of a structure's lifetime is that of construction, leading to failures or locking in forces and deformations that...
Standards for Design Loads During Construction: An ASCE Effort
ASCE embarked on a new standards activity by the Design Loads for Structures During Construction Standards Committee. The objective of the effort is the development of standard guidelines...
An Overview of the U.S. Coordinated Program for Masonry Building Research
The U.S. Coordinated Program for Masonry Building Research is a time-phased set of specific research tasks addressing materials, component and system behavior. The objective of the program...
Influence of Nonlinear Models on Dynamic Displacements
This research is a part of an ongoing multi-year program that is sponsored by the National Science Foundation and conducted under the TCCMAR (Technical Coordinating Committee for Masonry...
Durability Design for Concrete Bridge Structures
The concept of durability design for concrete structures including bridge structures is proposed on the basis of comprehensive evaluation of materials, design details and construction...
Dynamic Response Prediction for Earthquake Resistance Design of Bridge Structures
Newly developed nonlinear analysis procedures for assessing the earthquake resistance of bridges have been incorporated into the computer program SEISAB (SEISmic Analysis of Bridges)....
Vertical Response Data from the Dominion Road Bridge Test
In January and February of 1985, two bridges were tested in New Zealand using simulated earthquake loads. The objective was to determine the in-situ seismic response of two reinforced...
Consequences and Achievement of Supplemental Damping for Improved Seismic Performance
An earthquake resistant design philosophy which relies upon increased stiffness and damping rather than increased strength and ductility has been investigated. The effect of adding supplemental...
Earthquake Damage Estimates of Conventional and Isolated Structures
The philosophy inherent in current seismic design codes for buildings accepts the premise that there will be both structural and non-structural damage but that life safety will be preserved....
Earthquake Resistant Design Using Friction Pendulum Connections
The Friction Pendulum System (FPS) offers a simple approach for increasing a structure's earthquake resistance. The approach uses steel connections which absorb earthquake...
Friction-Dampers for Economic Seismic Design
A novel structural system, which combines the strength and stiffness of a braced frame and energy dissipation capacity of the friction-dampers, has been used in the design of a reinforced...
N-Pad?A Three-Dimensional Program for the Analysis of Base-Isolated Structures
N-PAD is a three-dimensional computer program especially written for the analysis of base-isolated structures. The program is designed with the ability to model various types of isolation...
Strong-Motion Records from Buildings
Since the establishment of the California Strong Motion Instrumentation Program in 1972, over 90 buildings have been instrumented extensively to measure their response during earthquakes....
Seismic Evaluation of a Tall Reinforced Concrete Frame Building
Accelerations at basement, fifth and tenth floor levels of a reinforced concrete apartment building were recorded during the October 1st, 1987 Whittier-Narrows earthquake. These accelerations...
Seismic Design of Highrise Building with Mega Frame
The NEC corporation head office building is under construction at Shiba Minato-ku, Tokyo, Japan. This building is a highrise building of steel structure with the height of 180m. The structural...
Return to search