Behavior of a Crack Under Reversed Cyclic Loading
The results of two series of basic experimental studies for opening and closing behavior in RC members are reported. For the first series, axial forces were applied to the specimens in...
Ultimate Strength and Deformation of RC Panels
In this study, twenty reinforced concrete panels have been tested under pure shear. Test results showed that the compressive strength of concrete strut was strongly affected by bond characteristics...
Wood Diaphragms: Performance Requirements and Analytical Modeling
Wood diaphragms represent the principal mechanisms for resisting lateral loads in many light-frame buildings. While recent research has provided several mathematical models for predicting...
Shear Strength of P.P.C. Beams
50 beams of partially prestressed concrete were tested and 82 data of the ultimate shear-strength were obtained. Based on these results, this paper studies the effects of the degree of...
Macroscopic Models for R/C Shear Walls
In this paper, the discussion is mainly focused on four macroscopic models, recently proposed by Japanese researchers, for predicting ultimate strength of reinforced concrete (R/C) shear...
Verification of Macroscopic Models for R/C Walls
Macroscopic models utilized in a plastic analysis for predicting the ultimate strength of reinforced concrete members have been developed in Japan as well as in Europe. In the JCI committee,...
LRFD for U. S. Bridge Design ? Validation Issues
During the 1987 meeting of the AASHTO Subcommittee on Bridges and Structures, recommendations from the National Cooperative Highway Research Program (NCHRP), Project 20-7/31, regarding...
An Overview of the Round-Robin Analysis of the 1:6-Scale Reinforced Concrete Containment Model
The results of nonlinear structural analyses of a 1:6-scale reinforced concrete model, which were independently conducted by ten different organizations, are briefly described and compared...
Development of a Test Validated Methodology for Predicting Concrete Containment Leakage
In the past several years, considerable research effort has been devoted by the Electric Power Research Institute and the U.S. Nuclear Regulatory Commission to the behavior of reactor...
Strength Evaluation of Existing Reinforced Concrete Structures
The load test as described in ACI 318-83 Chapter 20, entitled 'Strength Evaluation of Existing Structures,' was conducted at 60%, 80%, and 100% of the calculated...
Energy Approach of Earthquake-Structural Design Analysis
A new procedure developed from the earthquake energy concepts is presented in this paper. A short-squat building and a long-slender building are analyzed using the presented procedure....
Mitigation of Wind-Induced Vibration of Tall Buildings
This paper summarizes a detailed study of the sensitivity of building acceleration to changes in structural stiffness, mass and damping and to the eccentricities in the centers of stiffness...
Aerodynamic Methods for Mitigating Wind-Induced Building Motions
Excessive wind-induced motions of tall buildings most frequently result from vortex shedding induced across-wind oscillations. This form of excitation is most pronounced for relatively...
Dynamic Response of a Building with Dual System
The paper presents the dynamic response of a 30-story building with dual system consisting of cross-bracing and beam-column moment resisting frames. Two types of beam-column connections,...
Analysis and the Design of Multi-Layer Viscoelastic (V.E.) Dampers for Tall Structures
Vibrational motion of tall buildings can be damped by employment of viscoelastic passive dampers in the structure. The type of dampers selected depend on locations where relative displacements,...
Local Wind Pressures on Roofs
The paper reviews the results of the most recent research studies in the evaluation of wind pressure coefficients for the design of roof cladding elements. The effect of roof geometry...
Wind Performance of Asphalt Roofing Shingles
Pre-seal and post-seal wind resistance of asphalt roofing shingles is discussed. A test method for evaluating pre-seal wind damage is described. Wind tunnel testing results are presented...
Ballasted Single Ply Design Guide Development
A new roofing concept called ballasted single ply has now captured about 25% of the new and retrofit flat roof market. This concept relies on the use of ballast to provide the wind resistance...
Flexural Strength of Ultra-High Strength Concrete Members
Various proposals have been made for the pridiction of strength of high strength concrete sections. One of the most important parts of any strength computation procedure is the assumption...
Load and Resistance Factor Design for Engineered Wood Construction
The wood industry has provided sponsorship for the development of a reliability-based, load and resistance factor design specification for engineered wood structures. This user-tested,...
Return to search