Treating Sewage in One Tank
A sequencing batch reactor (SBR) was the answer to a sewage problem that was holding up community development in Poolesville, MD. Poolesville was one of the first municipalities in the...
Drying Out
Treatment plants are most efficient when they're treating waste, not water. Spurred on by increased fuel prices, a number of new technologies have been developed that can...
Asphalt Pavement Modifiers
Modifiers or additives to asphalt concrete pavements are being researched or marketed by many major chemical firms. Modifiers or additives are used to stiffen the asphalt in hot weather...
Bugs and Carbon Make a PACT
At its Chambers Works in southern New Jersey, DuPont was ordered to sharply reduce the BOD load in the wastewater it discharged to the Delaware River. Out of this mandate came the PACT...
Liquefaction Study of Coal Refuse by Nuclear Gauges
This paper presents a technique for utilizing nuclear gauges to determine density and moisture content continuously throughout refuse embankments and slurry reservoirs. The nuclear measurements...
Cone Penetrometer Use on Uranium Mill Tailings
Piezocone data were found to be very reliable in the identification of uranium tailings according to the traditional categories of sands, sand-slime mixtures, and slimes by the use of...
Implications of Soluble Microbial Products (SMP) Formation on Biofilm Reactor Performance
The objective of this study is to evaluate the implications of SMP formation for biofilm treatment. To do so, the extended steady-state model was applied to predict effluent concentrations...
The Optimization of Nitrification and Denitrification in Plug-Flow Activated Sludge Systems Treating Municipal Wastestreams
Most conventional plug-flow activated sludge plants experience nitrification, particularly during higher temperature conditions. Under these circumstances, additional power is required...
Predicting Radon Transport by Vegetation
Establishment of a vegetative cover on waste sites containing **2**2**6Ra (Radium) may provide conduits for transport of **2**2**2Rn (Radon) out of the waste into the above-ground environment...
Recyclying of Dust from Electric Arc Funances�An Experimental Evaluation
Each year the electric arc steelmaking industry generates approximately 650,000 tons of dusts containing valuable metallic resources such as iron, zinc, lead, and chromium. EAF dust is...
Combustion Sources of Residential Air Pollution: An Overview
Combustion by-products are a major source of indoor air pollution and have been measured in homes at levels above typical outdoor concentrations, and at levels which approach or exceed...
Design Considerations and Experiences with VOC Treatment Technologies
This paper presents a review of design considerations and experiences with packed column aeration for removal of volatile organic chemicals (VOC) from groundwater at various locations...
Emission and Control of Volatile Organics in Hazardous Waste Landfills
Landfill simulation and modeling can provide a useful tool in the management of hazardous wastes to estimate the vapor phase emissions of pollutants so that a realistic assessment can...
Testing of Permeable Materials for Retaining Contaminants in Subsurface Leachates
The use of a permeable, retentive treatment system could remove both organic and inorganic contaminants while still allowing flow. A testing procedure for determining the amounts of priority...
Permeability of Grouts Subjected to Chemicals
This paper presents the more recent results of a testing program which evaluated the long-term resistance to percolation of grouted soils, using acrylate, urethane and cement-bentonite...
A Field Study of Water Movement Through Clay Liners
A monitoring system has been designed for the field verification of a numerical model of water movement through the cover clay liner of hazardous waste landfills. The most unique aspect...
Decreasing Clay's Permeability Using Aluminum Salts
The permeabilities of montmorillonite and kaolinite clays were reduced by precipitating aluminum hydroxide in the pores of the clay. The precipitate was formed by permeating the clays...
Design of Final Covers for Landfills
Final covers or caps are incorporated into a completed landfill to limit the amount of moisture percolation through waste materials. A properly designed final cover system provides the...
Effects of Industrial-Municipal Co-Disposal
A study was conducted to evaluate the physical, microbiological, and chemical conditions of nineteen experimental landfills after the completion of a ten-year long municipal refuse/industrial...
Hydrogeologic Investigation of the Chillicothe, Ohio Landfill
A hydrogeologic investigation of a municipal waste landfill determined that the local surface and ground water are being polluted. Water quality monitoring and aerial photography were...
Return to search