Comparative WWind Tunnel Testing of Bridge Road Decks
A 1:75 scale full aeroelastic model of the Quincy Bridge over the Mississippi River was tested in the National Research Council of Canada 9 m multiplied by 9 m wind tunnel. Tests were...

Sunshine Skyway Ship Collision Criteria
The 'new' crossing of Sunshine Skyway was born, not only to replace the previous crossings and improve the regional economy but also with increased clearances...

Wind Buffeting of Long Span Bridges with Reference to Erection Phase Behaviour
The balanced cantilever technique for cable-stayed bridge erection can lead to an unacceptable buffeting response at high wind speeds unless the erection scheme is carefully studied. The...

Safety of Long Span Highway Bridges Based on Dynamic Response
This paper consists of an analytical study regarding the dynamic response of highway bridges subjected to heavy vehicle loads, with emphasis on long span low fundamental frequency bridges....

The Far? Bridge?Long Life at Low Costs
The superstructure of the bridge is a steel structure which proved to be competitive compared to the tendered concrete solution, due to simple and rational design both structurally and...

Application of Normal Integration Formulas to Bridge Reliability Analysis
Structural reliability analysis often involves extensive integration of complex multivariable functions. Special techniques can be used to reduce this numerical effort. This paper deals...

Comparisons of Full Scale and Wind Tunnel Model Response to Wind of Long Span Bridges
There are several vital reasons for measuring the response of full scale structures to wind and comparing the results to models - both experimental and analytical - employed in design....

Aluminum Orthotropic Bridge Deck Verification
This paper reports tests conducted to evaluate an aluminum orthotropic deck. Approximately 60 welded T-joints with 6061-T6 stems and 5456-H321 plate were subjected to flexural fatigue...

Fatigue Design Criteria for Welded Steel Details
A review of fatigue data and reassessment of the 1983 fatigue specification resistance functions has been conducted. Since the AASHTO specification fatigue resistance provisions were introduced...

Fatigue Strength of Welded Wire Fabric
Long life fatigue tests were made on 12 concrete slabs reinforced with large diameter, Grade 75, deformed welded wire fabric. The specimens simulated, to full scale, conditions in a bare...

Case Studies of Displacement-Induced Fatigue
The potential for displacement-induced cracking is a result of the co-existence of two conditions: an abrupt change in stiffness and a periodic force opposing it. Case studies of retrofitted...

Role of Microcompiuters in Highway Weigh-in-Motion Systems
Microcomputer technology makes it possible to digitize the signals, calculate the desired factors, and record and display the information in real time at the weigh-in-motion (WIM) site....

Microcomputer Assisted Bridge Rating
Before microcomputers can be useful to those officials responsible for rating the approximately 576,000 bridges in this country, software systems must be developed to analyze and rate...

Bridges and Transmission Line Structures
This volume on Bridges and Transmission Line Structures contains papers from ten sessions and one plenary session of the 1987 ASCE Structures Congress. Eight sessions cover bridges. A...

Earthquakes Will Not Damage This Bridge
A California pipeline bridge has been retrofitted with isolation bearings that damp earthquake shocks. The bridge over Southern California's Santa Ana River carries the Upper...

Connecticut: A Success Story
The Connecticut Department of Transportation (ConnDOT) had warned the state legislature that its highways and bridges would continue to deteriorate without increased funds for inspection,...

The Wet Look
The collapse of the Schoharie Creek bridge drew attention to underwater inspection. Underwater inspection of bridges gives engineers a better understanding of the condition of the bridges....

The Just-in-Case Factor
Computer analysis allows bridge designers to take a more precise look at the old structural principle of redundancy. No one can define redundancy, but everybody knows what it means. Two...

Twisting in the Wind
Wind tunnel tests are being used increasingly to test the aerodynamic stability of bridges. Many designers think these tests should be used early in the conceptual design stage, rather...

Wind Loading and Wind-Induced Structural Response
A State-of-the-Art Report
This state-of-the-art report presents fundamental and practical aspects of modern wind engineering practice as it relates to structural design. The first chapter includes information on...

 

 

 

 

Return to search