Channel Response to SCS Type-C Grade-Control Structures on Burney Branch, Mississippi
Five SCS Type-C grade-control structures were installed in Burney Branch in 1980 to remove 59.4 feet (18.1 m) of grade. The performance of the structures was evaluated in 1984 after they...
Analysis of Spillway Failures by Uplift Pressure
Results of a model study to evaluate the development of uplift pressures beneath concrete chutes are presented. Two spillway failures are described to support the study results. Common...
Estimation of Uplift Pressure in Cracks in Concrete Gravity Dams
This paper presents an analytical solution to predict uplift pressures in cracks in concrete gravity dams. It is shown that drainage systems are effective in reducing such pressures....
Design and Performance of Earth Spillways
The U.S. Department of Agriculture's Soil Conservation Service has designed and administered construction of a large number of dams utilizing grassed earth-lined auxiliary...
Mathematical Model of Wave Induced Pressures
A two-dimensional, implicit finite difference model was built to compute surface wave induced pressures under a gravity base foundation. The results showed considerable wave attenuation...
Sediment Survey of Lake Powell
The 1986 Lake Powell Sediment Survey documented the present storage-elevation relationship and loss of storage from sediment accumulation since the reservoir began filling. From the calculated...
Performance Evaluation of Channels Stabilized with ARS-Type Low-Drop Structures
Field and hydraulic investigations of seven ARS-type low-drop grade-control structures located in Mississippi indicate that most of the structures become submerged during flows with recurrence...
Gas Transfer at Hydraulic Structures
Field measurements of gas transfer at hydraulic structures are notoriously difficult and imprecise. A technique which measures the transfer of hydrocarbon tracer gases has been tested...
Expert System for Mixing Zone Analysis of Aqueous Discharges (CORMIX1): Further Developments
Two recent publications have reported the development of the Cornell Mixing Zone Expert System (CORMIX) for the analysis, prediction and design of aqueous toxic or conventional pollutant...
Dam Safety, Yes.; But What About Safety at Dams?
Design and construction of safe structures are the professional obligations of hydraulic engineers. However, there are environmental dangers with safe structures which engineers often...
Hydraulic Effects on Swimming Fish in Fish Passage Structures
The implications of profile drag, weight, and buoyant forces on energy and power requirements of fish swimming through fish passage structures are considered. Where hydraulic grade lines...
Flow Through Fish Bypass Intakes
Hydraulic and computational fluid dynamic models were used to investigate the cause of the unequal intake flow distribution observed entering the three vertical intakes of the patented...
Physical Model of Local Scour at Grade Control Structures
A physical model of local scour occurring at grade-control structures was operated at an undistorted Froude number prototype-model scale ratio of 1:4. The maximum unit discharge in the...
Design of Riprapped Scour Holes for Flip Bucket and Overfall Spillways
Presented in this paper is a simple method of predicting pre-excavated scour depths and geometry for riprapped basins below flip bucket spillways. The input data needed for establishing...
Task Committee Report on Reliability Analysis of Water Distribution Systems
The results of the ASCE Hydraulics Division Task Committee on Reliability Analysis of Water Distribution Systems are summarized in a very comprehensive report entitled Reliability Analysis...
New Methodology for Determining the Optimal Rehabilitation and Replacement of Water Distribution System Components
A methodology is presented for the determination of the optimal timing for the rehabilitation/replacement of water distribution system components in order to minimize costs. In this model...
Fractional-Step Method for Two-Dimensional Estuarine Transport
The fractional-step method was used in this study to split the longitudinal advective transport term from the other terms in the two-dimensional, laterally-averaged equation for estuarine...
A Numerical Solution Technique for Incompressible Flow
Presented is a numerical solution technique which employs the explicit predictor-corrector scheme of R.W. MacCormack in solving the governing two-dimensional equations of motion on a staggered...
Density Currents and Their Application in Hydraulic Engineering: Task Committee Progress Report
The Task Committee on Density Currents and Their Applications in Hydraulic Engineering operates under the Technical Committee on Hydrologic Transport and Dispersion. The Task Committee...
Terrestrial Trends for Building Technology in North America
This paper discusses new building technologies that will develop in the early 1990's to become significant technologies by the mid 1990's. The perspective is...
Return to search