Calibration of Redundancy Factors for Highway Bridges
The object of this study is to develop a framework for considering redundancy in design and load capacity evaluation of highway bridge superstructures. The proposed method consists of...

Structural Reliability and Proof Testing for Highway Bridges
This paper proposes a set of reliability-based proof load factors for highway bridge evaluation, to determine target proof load and load rating. The target safety index used is consistent...

Bridge Overloading Criteria
Considerable concern is being expressed by the public and government agencies over the deteriorating state of the country's infrastructure. At the same time, there is a general feedling...

On the Fatigue Loading for Local Components
Fatigue provisions in the North American Codes for design of highway bridges may not be applicable to the design of local components which are subjected to high axle overloads and dynamic...

Live Load Models Based on WIM Data
The objective of the paper is to present the results of weigh-in-motion (WIM) measurements carried out in Michigan. Selected bridges were instrumented and truck weights and axle configurations...

Road and Airport Pavement Response Monitoring Systems
This proceedings, Road and Airport Pavement Response Monitoring Systems, consists of papers presented at the symposium held in West Lebanon,...

Highway Design in 3-D
Limitations in the flexibility and intelligence of commercial roadway design packages led Hart-Freeland-Roberts, Inc., Brentwood, TN, to write its own highway design software. From the...

The Evolution of an Environmental Monitor
After more than 40 years of planning, litigation, design and construction, one of the nation's most controversial highway projects is finished. The completion earlier this...

Expert Systems: Ready to Hit the Road?
Expert systems, programs that take the rules a person uses to solve a problem and encodes them into a computer, are starting to get serious examination from DOTs around the country. The...

Summary Conclusions & Recommendations of the 1991 Washington State Ports and Transportation Systems
Since 1975, the Washington Public Ports Association and Washington State Department of Transportation (WSDOT) have conducted periodic performance assessments of the state's ports, waterways,...

Alameda Transportation Corridor
The Alameda Transportation Corridor is a significant new commitment on the part of the Ports of Los Angeles and Long Beach to improve and increase rail and highway access and capacity...

Earthquake Damage Repair and Retrofit of the Seventh St. Terminal Port of Oakland
The October 17, 1989 earthquake resulted in the collapse of the two-level Cypress St. Freeway in Oakland. Television and newspaper coverage revealed the tragic loss of life and property...

Terminal Asphalt Patching: An Innovative Approach
Asphaltic concrete has dominated the terminal industry as the pavement of choice for years. It is readily available and economical to install but requires considerable maintenance expense....

Container Terminal Gates Flexible Design for a Dynamic Environment
A paper entitled 'Container Terminal Gate Efficiency Hinges on Flexibility' was presented at ASCE Ports '89 by Larry Nye of Cash & Associates Engineers. The paper summarized the...

Hydrologic Investigation of the April, 1983 Flooding in New Orleans, Louisiana
During the rainstorm of April 6-7, 1983, a shell ramp was constructed over State Highway 406, closing the relatively shallow depression formed by the roadway passing over the levee which...

Two-Dimensional Hydraulic Analysis of the Owensboro Bridge and Approaches
The Kentucky Transportation Cabinet, Department of Highways, is working with the Indiana Department of Transportation and the Federal Highway Administration to plan, design, and construct...

Highway Construction and a Trout Stream Relocation
In 1970, a ten-mile section of Traffic Route 15 in the northern portion of Lycoming County extending into Tioga County was under design as a two-lane limited access highway on four lane...

Analytical Hydraulic Modeling of Road Culverts
This paper summarizes the development of a comprehensive analytical methodology and a computer model capable of simulating a wide range of flow phenomena in road culverts. The new flow...

OCEA, American-Style
A truly All-American contingent, the nominees for this year's Outstanding Civil Engineering Achievement award span the continental U.S., Alaska and Hawaii. The scope of the...

The Diagnosis of Pavement Ills
The paper defines the 'health' of a road pavement in terms of parameters of serviceability, safety and structural integrity and defines 'illness' as any departure from 'healthy' values...

 

 

 

 

Return to search