Limitation to Standard Parshall Flume Calibrations
Parshall flumes are widely used for metering open channel flows. An inspection of the original study which developed the rating equations indicates that the flumes were not tested for...
Selection of Hole Size for Fluidization Pipes
Two-dimensional fluidization experiments are performed on fine and medium coarse quartz sands at depths of 25.4 and 42 cm. Four supply pipes are used with orifice diameters of 1.587 mm...
Heat Development and In-Situ Strength of Large Diameter Caissons Made with High-Strength Concrete
The test program essentially consisted of casting two prototype caissons using two different high-strength concretes, measuring internal caisson and adjacent soil temperatures, extracting...
Cold Regions Hydrology and Hydraulics
The Cold Regions Hydrology and Hydraulics Monograph is the eighth in a series of monographs prepared by the ASCE Technical Council on Cold Regions Engineering. The book is intended to...
Full-Scale Measurement on Chiba Port Tower
Chiba Port Tower is a tall tower, 125m high, with a rhombus shaped plan. All of the surfaces are covered with half mirror glass. On the top of the tower, a 'Tuned Mass Damper'...
Pressure Measuring System for Wind Loads
A project to acquire wind and building surface pressure data in the field is continuing at Texas Tech University. A test building of dimensions 30 ? 45 ? 13 ft (9.1 ? 13.7 ? 4.0 m) and...
Pressuremeter Evaluation of Glacial Till Bearing Capacity in Toronto Canada
Glacial tills were evaluated at three Toronto sites, using conventional methods, the pressuremeter and full scale caisson load tests. The geologic environment and specific subsurface conditions...
Some Dilatometer Test Results in Pennsylvania and New York
This paper starts with a brief introduction to the dilatometer and piezoblade. Test results in four different areas are presented. DMT soundings at LR 67057 (Legislative Route numbers...
Settlement Characteristics from Insitu Tests in Flyash Structural Fills
Flyash from the Baltimore Gas and Electric Company's plants was used to construct structural fills in thickness ranging from 5 to 25 feet (1.5m to 7.6m). Several warehouses...
Low Cost Wave Measurement Program
This paper addresses some problems related to a wave measurement program in the coast emphasizing costs, environmental hazards and technological problems. Subjects covered include coastal...
In Situ Determinations of Dispersion and Transport Parameters at Piraquara De Fora (RJ)?Brazil, With Help of a Fluorescent Dye Tracer
This paper deals with 'in situ' determinations of the transport and dispersion parameters at Piraquara de Fora cove, near the site where the first Brazilian nuclear...
Estimating Soil Gas Flow Rates and Identifying Entry Routes in a Dwelling Using Multiple Perfluorocarbon Tracers
Passive monitoring of indoor air and below basement floor (subslab) soil gas for radon and perfluorocarbon tracer (PFT) gas concentration was conducted to investigate the influence of...
Indoor Radon: Site Evaluation
The soil parameters most important in evaluating the indoor radon potential of a building site are the soil radium concentration, the soil-gas radon concentration and the permeability...
Mass Balance Analysis of Decomposed Refuse in Laboratory Scale Lysimeters
Decomposition of shredded municipal refuse was studied under laboratory conditions with leachate recycle and neutralization. Cellulose and hemicellulose accounted for 91% of the methane...
Effect of Flow Conditions on Stream Reaeration Coefficients
Contrary to the findings of previous studies of channel-controlled stream reaches, it was found that, in four reaches of a small stream characterized by a series of pools and riffles,...
In Situ Measurement of Preferential Flow
An experiment was performed that quantifies the variability of flow paths in the vadoze zone. Bromide tracer and an organic dye, which has many of the same transport characteristics as...
Drought Investigations by the Use of Maximum Daily Temperatures
By the use of maximum daily temperature data, drought events can be defined by taking a certain truncation level to form the partial drought duration series. A drought series representing...
The Alabama Rainfall-Runoff Model, ARRM
ARRM consists of a conceptual state-space model which is cast in a stochastic framework. It uses the W.H. Green and C.A. Ampt method for infiltration, exponential decay for interflow and...
The State of Art of Physical Modelling of Sediment Transport
The paper attempts formula some ideas about the state of the art in the field of physical modelling of sediment transport processes. Up to now the physics of sediment transport are not...
Application of 2-D Model to Reduce Sedimentation Problems
The Corps of Engineers opened Lock and Dam No. 1 on the Red River Waterway in 1984. During the first runoff season, excessive quantities of fine sediment deposited in both the upstream...
Return to search