Expert System for Bridge Scour and Stream Stability
Significant engineering judgment is required to ascertain the scour susceptibility of bridges. This judgment is typically acquired through many years of experience. This paper describes...
BRICAL: A Multimedia Intelligent Educational System for Bridge Engineering
This paper discusses the development of a multimedia intelligent educational prototype system for bridge engineering called BRICAL. BRICAL uses information networks to express the relationships...
Bridge Condition Rating Using Fuzzy Sets and an Eigenvector of Priority Settings
A simplified methodology for combining the condition rating of the various elements of bridge components (deck, superstructure or substructure) is developed using a multi-attributive decision...
Conceptual Design Using Evolutive-Cognitive Computing Techniques
The paper concerns the development of a computer-based capability for conducting conceptual design using emergent(self-organizing) computing paradigms that arrive at a solution through...
53 WAK Tests on Spread Footings
Research on the prediction of soil stiffnesses of spread footing-soil systems using Wave Activated Stiffness (K) or WAK tests was conducted. As discrete lumped-parameter model with a mass,...
Footing Load Tests on Sand
Four full size footings were load tested at a site in Texas. The embedded footings were situated on a thin layer of stiff clay underlain by a thick deposit of medium dense to dense sand....
Settlement Behavior of an Avalanche Protection Gallery Founded on Loose Sandy Silt
An avalanche protection gallery located in the Swiss Alps was founded on alluvial ground close to the steep rocky mountainside. The rear retaining wall, at a variable distance of a few...
Testing and Predicting the Movement of a Drilled Shaft in New Mexico
The New Mexico State Highway and Transportation Department (NMSH&TD) have been using drilled shafts for supporting bridges in the State of New Mexico. Several drilled shafts were...
Prediction of Settlements of Footings on Sands: Accuracy and Reliability
Serviceability limit states are controlled by the deformations that a specific structure can undergo. This aspect involves a correct design of foundations to ensure that the supported...
Seismic Settlement of Shallow Footings on Sands
In this contribution, the progressive seismic settlement of shallow footings on cohesionless soils is calculated using a sliding block model. Beyond a critical horizontal acceleration,...
Comparison of Settlement Predictions for Single Piles in Sand Based on Penetration Test Results
The analysis of settlement for driven piles in cohesionless soils is a complex soil structure interaction problem. The total settlement for such a pile is generally considered to be the...
Footing Modulus Near Slopes
A method is described for estimating the footing modulus of shallow spread foundations located near slopes of cohesionless material. The ratio of footing modulus for a shallow foundation...
Settlement and Deformation Response of a Bridge Footing on a Sloped Fill
The problem of settlement of spread footings located within or near granular slopes has been investigated in the laboratory using a large testing facility. Based on these results, footings...
Settlement Measurements of 50-ft High Embankments at the Chesapeake & Delaware Canal Bridge
This is a case history of instrumented settlement measurements on 49 to 56' (15-17 m) high bridge approach embankments of Delaware State Route 1 crossing of the Chesapeake & Delaware...
Load-Settlement Prediction of Footings on Steep Slopes
The use of spread footings on slopes is a common practice in the design of bridge foundations. Footings are generally constructed in the slope or at its crest to minimize the bridge length,...
Numerical Modeling of Bridge Approach Settlement with Foundation-Embankment Interaction
Bridge approach settlement is one of the major problems facing the transportation agencies responsible for road construction and maintenance in the United States and in many other countries...
Tolerable Deformations
Current criteria for tolerable movements of buildings, bridges and other structures are reviewed. Tolerable values of total and differential settlement, relative rotation, relative deflection...
Stress and Settlement of Footings in Sand
In current engineering practice, the magnitude of the settlement of a footing in sand, as compared to the settlement of a different size footing in the same sand, is considered to be a...
Load Settlement curve Method for Spread Footings of Sand
A newly developed method is presented to predict the complete load settlement curve for square spread footings on sand loaded at their center with a vertical load and with an embedment...
Test and Prediction Results for Five Spread Footings on Sand
A separate volume summarizes this prediction symposium. It is available from ASCE in New York and is entitled as listed above. This prediction event took place during the conference and...
Return to search