Heath Building?Load Paths of an Underpinning
A case study of an underpinning is presented which, in principle, consists of the introduction of a transfer system in an existing building. The transfer system modifies the load paths...
Codified Reliability for Structures During Construction
It is generally acknowledged that the most critical stage of a structure's lifetime is that of construction, leading to failures or locking in forces and deformations that...
Standards for Design Loads During Construction: An ASCE Effort
ASCE embarked on a new standards activity by the Design Loads for Structures During Construction Standards Committee. The objective of the effort is the development of standard guidelines...
Remote Automatic Data Acquisition Systems
Personal computers have been used on two projects to monitor peformance of structures in an automatically triggered mode. In both cases a local PC is used to continually monitor a triggering...
Pressure Measuring System for Wind Loads
A project to acquire wind and building surface pressure data in the field is continuing at Texas Tech University. A test building of dimensions 30 ? 45 ? 13 ft (9.1 ? 13.7 ? 4.0 m) and...
An Overview of the U.S. Coordinated Program for Masonry Building Research
The U.S. Coordinated Program for Masonry Building Research is a time-phased set of specific research tasks addressing materials, component and system behavior. The objective of the program...
An Education in Tunneling
In this follow-up to the author's article in the April 1989 issue of Civil Engineering, this senior civil engineer and winner of the 1988 Martin Kapp Foundation Engineering...
Suburban Superfund
Discovery of methane seeping into houses at a new development near Newark, Del. set off investigations that eventually led to the U.S. EPA declaring the site eligible for Superund cleanup...
Hydrogeology Comes to the Surface
Before concluding whether groundwater is safe or contaminated, engineers must understand the science of hydrogeology. If they don't understand hydrogeology, unnecessary and...
Rapid Visual Screening of Buildings for Potential Seismic Hazards
A Rapid Screening Procedure (RSP) developed for use nation-wide is based on a 'sidewalk survey' of a building, in which a Data Collection Form is completed by...
ATC 14: A Methodology for the Seismic Evaluation of Existing Buildings
A new method for evaluating the seismic resistance of existing buildings has been developed based on the historic performance of buildings in past major earthquakes. This methodology identifies...
ATC-22: Development of a Handbook for ATC-14
The ATC-22 project is the development of a Handbook for the application of the methodology of ATC-14 for the seismic evaluation of existing buildings. The development of the Handbook itself...
Postearthquake Safety Evaluation of Buildings
Procedures for the safety evaluation of buildings in earthquake damaged areas have been developed. Two evaluation techniques, Rapid Screening and Detailed Inspection, are described. Rapid...
Forced Vibration of Sliding Base Structural Systems
An analytical and experimental study of the effect of a horizontal sliding plane on the dynamic response of a single-story structure subjected to harmonic motion is presented. There is...
Earthquake Resistant Design Using Friction Pendulum Connections
The Friction Pendulum System (FPS) offers a simple approach for increasing a structure's earthquake resistance. The approach uses steel connections which absorb earthquake...
Friction-Dampers for Economic Seismic Design
A novel structural system, which combines the strength and stiffness of a braced frame and energy dissipation capacity of the friction-dampers, has been used in the design of a reinforced...
System Identification of Meloland Road Overcrossing
The Meloland Road Overcrossing (MRO) is a two-span reinforced concrete bridge structure located east of El Centro, California, 0.3 mi from the Imperial Fault. The Imperial Valley Earthquake...
System Identification of a Large Structure Using Pseudo-Dynamic Test Data
This paper deals with structural modeling and the determination of optimal nonlinear models by applying system identification techniques to inelastic pseudo-dynamic test data from a full-scale,...
Tradeoffs Between Active Control and Identification of Structural Systems
This paper explores the tradeoffs between structural identification and structural control in a quantitative manner. Through the intemediary concept of an optimal input, it is shown that...
Seismic Instrumentation and Its Implication for High-Rise Buildings in Japan
An outline of the present state of the strong earthquake motions observation systems in Japan and an example of the obtained records of an earthquake and its simulation analysis of a high-rise...
Return to search