Improved Design Procedure for Shallow-Buried Structures to Resist Airblast Loading
Both conventional and nuclear weapons generate airblast loads of sufficient magnitude that structure survival at acceptable cost favors below grade construction. The design of shallow-buried...
Fault Identification by Seismic Impact Load Techniques
The propagation of seismic waves generated by impact loading across a normal fault in carbonate rock was investigated by the seismic refraction technique. The field records were reduced,...
Rational Design Approach for Tension on the Net Section
A study of the bearing and net section capacities of bolt connections for material thicknesses encountered in cold-formed members was conducted. This paper summarizes the findings as they...
Behavior and Design of Semi-Rigid Composite Frames
Recent advances and experimental research on the behavior of composite semi-rigid frames indicates that substantial savings can be achieved with this method of construction. The current...
Moment Rotation Curves for Double Framing Angles
Moment-rotation curves for bolted framed steel connections are derived from force-deflection data obtained from laboratory tension and compression tests of angle segments. These derived...
Beam-Columns
The Fourth Edition of the SSRC Guide presents a state-of-the-art information on beam-columns for use by specification writers, researchers, and designers. The present paper is an extremely...
Effect of Connector Spacing on Double Angle Compressive Strength
The 1986 AISC 'Load and Resistance Factor Design (LRFD) Specification for Structural Steel Buildings' includes new rules affecting the design of built-up members...
Reliability Revision for Structures in Service
Models of structural reliability are called upon to provide not only initial estimates of safety, but also revised estimates reflecting new information on the structure as it becomes available....
Fracture-Mechanics-Based Fatigue Life Estimate
Fatigue lives of tee-shaped weldments are estimated using fracture mechanics concepts and crack growth rate data. Fracture mechanics is used to develop an approximate expression for stress...
Aluminum Orthotropic Bridge Deck Verification
This paper reports tests conducted to evaluate an aluminum orthotropic deck. Approximately 60 welded T-joints with 6061-T6 stems and 5456-H321 plate were subjected to flexural fatigue...
Fatigue Design Criteria for Welded Steel Details
A review of fatigue data and reassessment of the 1983 fatigue specification resistance functions has been conducted. Since the AASHTO specification fatigue resistance provisions were introduced...
A Fatigue Study of Prestressing Strand
Strand fatigue data reported in the literature and also from recent tests were combined to form a data base of strand fatigue data which was analyzed using regression analysis techniques....
Fatigue Strength of Welded Wire Fabric
Long life fatigue tests were made on 12 concrete slabs reinforced with large diameter, Grade 75, deformed welded wire fabric. The specimens simulated, to full scale, conditions in a bare...
Axial Fatigue Model for Wire Rope Strand
A numerical fatigue model for cables and rope strand subjected to fluctuating axial tension has been developed. This model determines the maximum wire nominal and Hertz contact stresses,...
Base Isolation for Reinforced Concrete Structures
A recent experimental program has been carried out at the Earthquake Simulator Laboratory of the Earthquake Engineering Research Center in which a 1/5th scale reinforced concrete structural...
New Directions in the Application of Probabilistic Concepts in the Seismic Analysis of Nuclear Power Plants
During the last 8 years, probabilistic concepts have been used in the seismic analysis of nuclear power plants. Probabilistic risk assessment (PRA) has been the primary vehicle for performing...
Projectile Penetration Into Reinforced Concrete and Steel Targets
This paper presents brief preliminary results of a research program sponsored by the Air Force Weapons Laboratory (AFWL) to investigate the interaction of 30-mm cannon projectiles with...
Geotechnical Practice for Waste Disposal '87
This volume contains 55 papers covering many aspects of geotechnical issues associated with waste disposal. The papers represent advances during the intervening decade since the first...
Rescuing the Everglades
After a century of trying to control Florida's Everglades, water management officials have decided that cooperating with nature is better. A new strategy known as the Rainfall...
A Burning Wasteland Reclaimed
Until recently the PJP Landfill exemplified what can happen when uncontrolled and illegal dumping goes on for many years. Now it is an example of what innovation and imagination can do...
Return to search