How Well do P.E. Exams Relate to the Real World? NCEE Tries to Find Out
The National Council of Engineering Examiners (NCEE), the group which furnishes a standard liscensing exam for professional engineers used by almost every U.S. jurisdiction, has surveyed...
Surveying and Photogrammetry Research Needs
An ASCE-National Science Foundation committee listed and prioritized research needs in surveying and photogrammetry. Among them are the Department of Defense's Global Positioning...
The Booming Business in Wick Drains
Prefabricated vertical wick drains, used to improve weak, saturated soils, have been used in Japan and Europe for 20 years but were introduced in the U.S. only four years ago. Since then...
Grouting in Geotechnical Engineering
The 63 pages included in these proceedings came from 12 different countries and deal with the pertinent advances in grouting materials and technology that have occurred throughout the...
Application of Plasticity and Generalized Stress-strain in Geotechnical Engineering
This volume on the application of plasticity and generalized stress-strain in geotechnical engineering is divided into two main sections, with an introduction on soil constitutive model...
Engineering and Construction in Tropical and Residual Soils
Thirty-one papers and six invited lectures presented at the specialty conference on engineering and construction in tropical and residual soils are included. The proceedings represent...
Cold Regions Engineering in Norway
The use of insulating materials is a key factor in cold regions engineering in Norway. It is applied in road construction in areas where frost heave and reduced bearing capacity would...
Sanitary Sewer Design
Good sanitary sewer design practice requires evaluation of alternative locations, slopes and pipe sizes. However, cost considerations generally keep alternative evaluations to a minimum....
Engineering Schools Respond to Financial Crisis
A mail survey of the 200-plus civil engineering departments at engineering schools asked each chairman for a case history of response to the financial and other crises facing the departments....
Environmentally Sound Water and Soil Management
These proceedings contain the papers and abstracts presented at the 1982 Irrigation and Drainage Division of the American Society of Civil Engineers Specialty Conference held in Orlando,...
Organic Chemical Fire in Illinois: Emergency Response and Cleanup
In April 1980 at Hillsboro, Illinois, a fire in an agricultural chemical warehouse generated a hazardous smoke plume, and some 250,000 gallons of water used in fighting the fire were highly...
Does Landfill Leachate Make Clay Liners More Permeable?
Most environmental regulations require that clay liners exhibit permeabilities less than 1 x 10/u-7 cm/sec. While permeability is typically determined...
Shanghai Tunnel Projects Spur Construction Innovations
Since underground construction in soft ground is newly developed in Shanghai, there is little experience there as compared to what is known for specific sites in other countires. Well...
Compression Rings Support Deep Cut
The plans for building the Cuyahoga Valley Interceptor Lift Station in Cleveland, Ohio, called for 126 ft. (38.4 m) by 105 ft. (32 m) construction, some 80 ft. (24.4 m) below grade. Bracing...
Unified Soil Classification System
The most common soil classification method used by foundation engineers in the United States is A Standard Method for Classification of Soils for Engineering Purposes, ASTM D-2487, usually...
ASCE Salary Survey 1981
This is the sixteenth report in a series of biennial salary surveys conducted by the American Society of Civil Engineers. Salary data is reported on seven major categories for civil engineers:...
The Northern Community
A Search for a Quality Environment
Fifty-eight of the papers prepared by individuals attending the 1981 Specialty Conference on the Northern Community are presented. The papers are organized into seven main subjects related...
Dynamic Consolidation - Dramatic Way to Strengthen Soil
The dynamic consolidation technique consists basically of dropping a heavy pounder of up to 4 x 104 kg from a height varying between 50 to 148 ft....
The ABC'S (and Q) of Cold-Formed Steel Design
Cold-formed structural members are steel components that have been put into their cross-sectional shape by cold bending of flat sheets. Local compressive buckling must be carefully considered...
From Field to Map�Untouched by Human Hands
After a few years of experience with computerized surveying systems, surveyors are finding that increased efficiency and accuracy are justifying capital expenditures. Several users of...
Return to search