Experimental Studies of Coastal Process and Improvement Works on Xiaodinggang Coast
The field observation and investigation in recent years show that the coast erosion in the area is mainly caused by rapid reduction of sediment supply. The deposit materials are uplifted...
Coastal Zone Management in Emilia-Romagna, Italy
The beaches of the seaside resorts in the Emilia-Romagna region are of great importance to the regional economy. During the last decades, certain natural and man-induced developments have...
Equilibrium Beach Profiles: Prediction of Coastal Erosion Due to Severe Storms
This paper describes a method that calculates coastal erosion due to severe storms. The equilibrium beach profile concept used in this study was developed by Swart. The agreement between...
Anadromous Fish Impacts at Proposed Hydroelectric Plants
This paper describes a series of field techniques successfully used by the authors to determine a minimum flow downstream of hydroelectric plants. The minimum flow of water required for...
Measurement and Use of Shear Wave Velocity for Evaluating Dynamic Soil Properties
Geotechnical engineers have recognized in the past decade that shear wave velocity is a basic soil property and have begun to use it to characterize sites for many uses. Most notable has...
Hydraulic Fill Dam Made Earthquake Resistant
San Pablo Dam, near the San Andreas fault, constructed in 1919-21 by hydraulic fill methods, was found to be susceptible in places to liquefaction under seismic loading. The dam has been...
Effects of Vehicles on Buried, High-Pressure Pipe
The mechanical effects of selected types of traffic on buried, high-pressure steel pipe are examined. Particularly considered is a section of the Colorado Interstate Gas (CIG) pipeline...
Clay Pipe Installation?Advances in Load Factors
This report presents an evaluation of traditional load factor values for clay pipe and the development of a new bedding system which gives a higher load factor. Tests demonstrate that...
Unique Installation Methods for Large Interceptor in Poor Soil Conditions
The construction of approximately 1. 5 miles of a major sewer interceptor in downtown Boston encountered some unique construction challenges. The entire route required dewatering during...
Stress-Intensification Factor and Flexibility Factor in Seismic Analysis of Continuous Buried Pipelines
The topics of intensified stresses and increased flexibility in pipe bends subjected to bending loads are discussed in this paper. Also discussed are dynamic strain compatibility between...
Bending Moment of Underground Flexible Pipes in a Centrifuge
The effect of several factors on bending moment of an underground flexible pipe section buried in a ditch with sheet piling was investigated experimentally by means of centrifugal model...
Field Burial Tests of Corrugated Double Wall PVC Pipe
A new lightweight PVC pipe, consisting of a smooth inner wall and a corrugated outer wall, has been introduced in the U. S. sanitary sewer market in 4 through 10 in. diameters. Field burial...
Long Term Deflection of Buried Plastic Sewer Pipes
During the 70's and the early 80's a research program has been carried out in Sweden regarding the long term behaviour of buried plastic pipes. The program has...
Determining the In-Place Density of Soils Using the Sleeve Method
The sleeve method of determining the in-place density was developed by Bureau of Reclamation field personnel for cohesionless, fine, gravel soils used for pipe bedding when other methods...
Buried Fiberglass Pipe Response to Field Installation Methods
In 1970 near Yuma, Arizona, a field test installation of 30 inch diameter fiberglass pipe was constructed. Twelve years later the pipeline was remeasured. Measurements of pipe profile,...
Long Term Testing of Centrifugally Cast Glass Fibre Reinforced Plastic Pipes (RIRP)
The paper discusses testing of pipe manufactured by centrifugal molding. The tests included external load tests, internal load, hydrostatic internal pressure, and cyclic internal pressure....
A Study of Inlet Control Alternatives for SWM
A laboratory study of alternatives for effecting inlet control on urban storm sewer systems for stormwater management (SWM) is described. The test facility was a full-size physical model...
Field Testing of 84-Inch-Diameter Plastic Pipe
During the summer of 1981, a research project was initiated to monitor strains and deformation in 84-inch diameter RPM (reinforced plastic mortar) pressure pipe. Three 20-foot (6. 1-m)...
Successful Use of Centrifugally Cast Glassfiber Reinforced Plastic (GRP) Pressure Pipes for Public Works in Sweden
Centrifugally cast GRP pipes were introduced in Sweden 17 years ago for industrial applications mainly as a gravity pipe. The process of pipe manufacturing as well as the pipe itself and...
Influence of Frost Action on the Load Exerted on Buried Pipe
When work was started on revising the Swedish code for concrete pipes at the end of the 70's, a research project was carried out to evaluate the risk of increased load due...
Return to search