Laboratory Fatigue Investigation of a GRP Bridge
A fatigue study of a 4.9 m glass-reinforced plastic bridge indicated a resistance to 1.6 million cycles of load without extensive damage to joints or elements. Viscoelastic creep occurred...
Size Effect in Concrete Structures and Influence of Loading Rate
The size effect law models the influence of the dimensions of the structure or specimen on the failure stress. This model can be used to quantify the brittleness of failure, and determine...
Flexural Strength of Externally Reinforced Concrete Beams
Results from tests of one rectangular and one T-beam are reported. The beams were strengthened by epoxy-bonding a 1/4 in. (6 mm) thick Glass Fiber Reinforced Plastic plate along the tension...
Uni- and Bi-Axial Compressive Fatigue of Fiber Concrete
Fatigue behavior of fiber reinforced concrete is studied under uniaxial and biaxial loadings. The S-N curves and the cyclic deformations of fiber concrete are compared to those of plain...
Inelastic Stability of Thin Walled Metal Tubes Under Cyclic Loading Conditions
This paper is concerned with an experimental investigation on the inelastic stability behavior of thin-walled tubular specimens of steel, aluminum and stainless steel, under cyclic loading...
Behavior and Strength of Telescopic Steel Shores
To study the load distribution between concrete floors and shores during construction, the non-linear axial load-shortening behavior of a single post shore must be modeled properly. In...
Stresses in Concrete Armor Units
This book is derived from a Seminar at the Waterways Experiment Station, Coastal Engineering Research Center, Vicksburg, Mississippi held on November 7-8, 1989. It presents a state-of-the-art...
Bibliography of Steel Columns
This book, which was prepared by the Committee on Compression Members of the Structural Division of the American Society of Civil Engineers, attempts to provide a complete bibliography...
50th Anniversary of the Hydraulic Division 1938-1988
This publication consists of the papers presented at the special sessions of the 1988 ASCE National Conference on Hydraulic Engineering held in Colorado Springs, Colorado, August 8-10,...
Hydraulic Engineering
This proceedings consists of papers presented at the ASCE National Convention on Hydraulic Engineering given July 30 to August 3, 1990 in San Diego, California. The Conference provided...
Hydraulics/Hydrology of Arid Lands (H?AL)
This proceedings consists of papers presented at the International Symposium on the Hydraulics and Hydrology of Arid Lands which was held in conjunction with the 1990 National Conference...
Commentary on Building Code Requirements for Masonry Structures (ACI 530-88/ ASCE 5-88) and Commentary on Specifications for Masonry Structures (ACI 530.1-88/ ASCE 6-88)
Seattle Swing
The swing bridge has long been out of favor in the U.S. because of the navigational hazard presented by mid-channel pivot piers. A consortium of engineers is updating the design to a state-of-the-art...
Structures Congress Abstracts 1990
Abstract only. The following themes are included: Rehabilitation and future challenges, Bridges, Earthquake engineering, Dynamic loads on structures, Metals and composite construction,...
Progress in Hydromechanics
The historical development of hydromechanics in the fifty years since the founding of the Hydraulics Division is reviewed. Rouse's 1938 text, Fluid Mechanics for Hydraulic Engineers, provided...
Advancement in Tidal Hydraulics
This paper will discuss advances in the field of tidal hydraulics since the inception of the ASCE Hydraulics Division 50 years ago. Activities of the Committees on Tidal Hydraulics of...
Contributions by the Hydraulics Division of ASCE to the Advancement of Ground-Water Hydrology
Papers related to ground-water hydrology published in Proceedings of the ASCE and in Hydraulics Division journals from 1938 through mid-1988 are briefly summarized. The areas covered are...
Research in ASCE's Hydraulics Division
Research in the Hydraulics Division of ASCE during the last 50 years has undergone changes in both technical content and procedures. Open channel flow, sediment transport and pipe flow...
Development of Hydraulic Structures
The Bureau of Reclamation was established in 1902. Since that time, Reclamation has constructed more than 220 dams. Each dam, depending on its function, has two or more principal hydraulic...
Cold Regions Hydrology and Hydraulics
The Cold Regions Hydrology and Hydraulics Monograph is the eighth in a series of monographs prepared by the ASCE Technical Council on Cold Regions Engineering. The book is intended to...
Return to search