Sprinkler System Design for Frost Protection
Both undertree and overtree systems for frost protection by sprinkling are currently being used. The criteria based on experimental results and theoretical modeling have been reviewed...
Infiltration or Roughness from Surface Irrigation Advance
Over the past several decades, a significant effort has gone into the development of mathematical models of water flow over the soil surface. Significant progress has been made in prediction...
An Assessment of Input Variables to the Penman-Monteith Equation Using Canopy Reflectance Measurements
Observing the form of the Penman-J.L. Monteith equation, it can be seen that several terms could be potentially estimated from remotely sensed data. These include: net radiation, canopy...
A Modern Approach to the Design of Grassed Channels
The design of grassed channels can be based on modern fluid mechanics principles. The resistance to flow in a grassed channel is linked directly to the relative roughness of the flow through...
Computation of Unsaturated Soil Parameters Using Upward Infiltration Empirical Data
The relationship between soil moisture content and hydraulic conductivity with the soil tension be defined to simulate unsaturated flow in a porous media. Direct measurements of these...
Strategies to Reduce Salt Load in Drainage Water
A study of irrigation efficiency, drainage flow and trace element loading in the drainage water from a 14000 ha irrigation district on the west side of the San Joaquin Valley of California...
Effect of Water Depth and Groundwater Table on Infiltration from Recharge Basins
The actual effect of water depth on infiltration depends on the depth to groundwater and on whether the wetted perimeter of the basin is clean or covered by a clogging layer of fine particles...
Rehabilitation of Water Wells
The main causes of declining well yield are biological growths, mechanical clogging and chemical encrustation. Because the treatment of the causes of encrustation and clogging is expensive...
An Evaluation of the Large Mammal Entry/Escape Steps Coachella Canal In-Place Lining Project
This study evaluated the effectiveness of a new system of large mammal entry/escape steps as part of the environmental investigations for the Coachella Canal In-place Lining Prototype,...
Design of Steel Transmission Pole Structures
Comparison of Design Rainfall Criteria for the Southwest
The design of drainage and flood control facilities or the management of floodplains for alluvial fans is extremely sensitive to the design rainfall criteria that is used as input to the...
Inclusion of Wetlands in Designated Floodway Studies
The purpose of this paper is to propose a change in the traditional methods and procedures used by hydrologist and hydraulic engineers to define floodways and floodway fringe areas. We...
The Bearing Capacity of Debris Flows
Debris flows are made of a cohesive muddy matrix in which large and heavy particles exist in suspension. To explain how these particles are maintained in suspension, several mechanisms...
Two-Dimensional Modeling of Alluvial Fan Flows
A two-dimensional, flood routing model FLO-2D has been developed to route water and mudflows over unconfined surfaces. It predicts flow velocities and depths at discrete points for channel...
Armor Layer Evolution
This communication presents an analysis of celerity propagation for non-uniform materials. Based on the corresponding flow, sediment transpot and sorting/armoring equations, the celerity...
Predicting Stream Width and Bank Retreat
The width of streams is dependent on the flood flow discharge which varies from year to year, the bank material which varies from stream to stream and reach to reach, the sediment load...
Hydraulic Bridge Design for Movable Bed Conditions
This paper addresses the practical considerations of hydraulic design of a bridge under movable bed conditions. Hydraulic design tasks include pier and abutment scour calculations, design...
Alignment of Large Flood-Peaks on Arid Watersheds
Bridge and culvert design requires estimates for 25- to 100-year return period flood peaks (Q). Floodplain delineation calls for 500-year (Q500) estimates. Arid western flood series are...
Multiple Phenomena of Debris-Flow Processes: A Challenge for Hazard Assessments
Hazardous hydraulic processes associated with arid environments commonly repesent significant risks to the safety of the public. However, the public generally considers these risks to...
Runoff and Erosional Processes in an Arid Watershed
This paper reports the results of geomorphic, hydrologic, and hydraulic analyses that integrated a physical process computer model of rainfall/runoff processes with a geomorphic process/response...
Return to search