Innovative New Drainage Pipe
Hydraulic tests on corrugated HDPE pipe with a smooth liner show that its Mannings n-value is in the range of 0.009 to 0.015 depending on the smoothness of the liners. With the smooth...
Review of PIM (Pipeline Insertion Method) Technology
The U.S. Army Construction Engineering Research Laboratory (USACERL) conducted the first demonstration of PIM (Pipeline Insertion Method, formerly Pipe Insertion Machine) technology for...
Stress Relaxation Characteristics of the HDPE Pipe-Soil System
All piping materials and soils are subject to viscoelastic behavior such as stress relaxation and creep. The combination of soil and pipe viscoelastic properties determine the time-dependent...
Corrosion Protection of Cast Iron and Ductile Iron Pipe, San Diego, California
This paper addresses the use of a loose unbonded plastic covering polyethylene encasement for protection of cast and ductile iron pipe in an extremely corrosive soil. The case study in...
Measured Performance and Numerical Analysis of Buried Pipe
This study shows that the behavior of a soil pipe system can be assessed by a nonlinear elasto-plastic finite element analysis. The results of numerical calculations are compared to the...
Design of Drainage Pipes Below Landfills
Drainage pipes are an essential component of landfills. Even though their embedment conditions differ substantially from those of pipes for municipal utilities near the ground surface,...
FE Elastic Analysis of Measured Earth Pressure on Buried Rigid Pipes in Centrifuged Models
FE elastic analyses of earth pressure on buried rigid pipes yielded results that agreed well with the earth pressure measured in 42 centrifuged models, confirming both the reliability...
The Effect of Compaction on Buried Flexible Pipes
This contribution presents an analysis of the installation of flexible pipes in granular soil. The deformation of the pipe cross section is measured in field and laboratory tests. It is...
Designing Vitrified Clay Pipe Systems with EASE
NCPI has developed a computerized trench load design program which provides a broad and complete spectrum of design options which will enable engineers and contractors to safely design...
Field Experiment on Behavior of Continuous Water Main with a Miter Bend
A field experiment was conducted to investigate behaviors of a buried continuous steel water main with a 90-degree miter bend subjected to internal pressure and ground settlement. Deformations...
Museum Showcases the Future
On May 4 in Philadelphia, the Franklin Institute's new wing, called the Futures Center, will open to the public. When the institute's neoclassic main buiding...
A Preliminary Model for Carbon-14 Transport in a Clay Buffer
A model has been developed to assess the effect of calcite dissolution and precipitation reactions on the transport of 14C through a saturated, calcite-containing...
Outline of Performance Assessment Study on Geological Isolation System in Japan
The goals of current R&D activities are to ensure the feasibility of geological isolation of HLW in Japan and then to establish the social acceptance. In order to attain these...
A Gas-Flow Source Term from a Nuclear Waste Container in an Unsaturated Medium
The potential nuclear waste repository at Yucca Mountain is to be in partially saturated rock. Released radioactive gases would have a direct pathway to the biosphere. The entry of air...
Diffusion Coefficients and Hydraulic Conductivity in Unsaturated Hanford Soils and Sediments
Two groundwater transport parameters of some Hanford formation materials, the hydraulic conductivity and the diffusion coefficient, were measured to aid in predicting contaminant migration....
Reconnaissance ? ??C and ??8O Data from Trench 14, Busted Butte, and Drill Hole G-4, Yucca Mountain, Nevada Test Site
Trench 14 was excavated to investigate the extent of Quaternary movement on the Bow Ridge fault, a north-south structure on the east side of Yucca Mountain. The trench exposes calcite...
Method for Determining the Fuel Contribution to the Source Term in Trasnport Casks
A comprehensive source term characterization methodology has been developed for the determination of the fuel contribution to the potentially releasable radioactivity in spent fuel shipping...
Post-MECO Propulsion System Requirements for Placement of an STS External Tank in Low Earth Orbit
This paper discusses the findings of a series of computer simulations carried out at the National Institute of Standards and Technology to investigate the requirements for powered flight...
Lunar Base Elements Designed for Robotic Operations
Equipment concepts developed for a study of robotic lunar surface operations are presented. The concepts were evolved together with a consistent robotic buildup and operations scenario;...
Motion Control of Space Structures
A new area of civil engineering is emerging as we begin to establish a permanent presence in space. The new area of civil engineering is the motion control of space structures. This paper...
Return to search