Cyclic Behavior and Seismic Design of Steel Base Plates
The objectives of this study were to conduct realistic experiments to understand cyclic behavior of steel column base plates and to develop seismic design recommendations. Six specimens...
A Comparison of the Cyclic Performance of Bolted and Riveted Connections
As part of a larger project to investigate the performance of older steel frames, a comparative study of bolted and riveted T-stub connections was conducted. The study included connections...
Some Unresolved Issues in Seismic Steel Codes
In the latest revisions of the three major U.S. seismic codes (AISC, NEHRP, UBC) some requirements can be questioned because of limited knowledge. Confining attention to conventional kinds...
Seismic Standards for Existing Federally Owned and Leased Buildings
Public Law 101-614 requires the Interagency Committee on Seismic Safety in construction to develop 'standards for assessing and enhancing the seismic safety of existing buildings constructed...
Nonlinear Response of SDOF Systems to Intraplate Earthquakes
It is well established that there are characteristics differences between intraplate and interplate earthquakes. A parametric study of SDOF systems indicates that there is also consistent...
Connectors for Earthquake Resistant Structures
Damage assessments from the past several earthquakes located on the northern, central and southern zones of the San Andreas Fault - Cape Mendocino: April 1992, 7.1; Loma Prieta: October...
The European Approach to Seismic Design of Engineered Timber Constructions: The Case of Low-Dissipative Structures
In the present paper the importance of the dissipated energy on the actual structural behaviour of low-dissipative structures as glulam portal frames with mechanical fasteners under seismic...
A General Hysteresis Model for Wood Structures
To predict the dynamic response of a wood structure, its energy dissipation mechanism and hysteresis behavior must be appropriately modeled. This paper presents a new hysteresis model...
Fire Retardant Treated Wood
The paper explains how FRTW chemicals react with combustible gases. It describes the two types into which FRTW is divided. Misconceptions about FRTW are also addressed....
Fire Endurance Model for a Metal-Plate-Connected Wood Truss
A numerical model has been developed for predicting the fire endurance of a single metal-plate-connected wood truss. Extensive component fire testing was conducted to develop the necessary...
Wind Design and Analysis for the Normandy Bridge
The Normandy Bridge will represent an important progress in the field of cable-stayed bridges, with a main span 856-metre long. This paper explains how the design has been oriented to...
Aeroelastic Study of Long Span Suspension Bridges: the Messina Crossing
This paper deals with wind actions on long-span suspension bridges. Particular reference is made to the Messina Strait Crossing. Problems encountered in this study, both for deck and towers,...
Full Model Wind Tunnel Tests for the Akashi Kaikyo Bridge
In order to carry out final verification of the wind resistance safety of the Akashi Kaikyo Bridge under construction, which has the largest main span of 1,990 m, its full aeroelastic...
A Wind Tunnel Study of an Aeroelastic Model of the Florida Suncoast Dome
Very large scale cable domes have been built using prestressed, high strength steel cable or strand, steel tube columns and a lightweight fiberglass skin. Geiger Engineers Florida Suncoast...
Effects of Drifting on Snow Loads on Large Roofs
In areas that experience significant snow fall, snow loads typically produce the governing environmental load cases for a large span roof. Therefore for large span roofs there are considerable...
Wind Loads on Arena Roofs Using Aerodynamic Models
The concept behind an aerodynamic wind tunnel model used to predict dynamic response to wind excitation is the generalized load in a particular natural mode of vibration is measured ,...
Design Wind Speed and Design Criteria of Buildings
Design load recommendations of Architectural Institute of Japan(A.I.J.) are revised according to a common principle to all kinds of loads. The basic wind speed is defined as the annual...
Wind Resistant Design and Response Control of Tall Building
This paper presents an overall view of the wind resistant design and response control of the tall buildings in Japan, the Crystal Tower in Osaka and the Landmark Tower in Yokohama. The...
Wind Resistant Design Manual for Highway Bridges
'Wind resistant design manual for highway bridges in Japan' has been published in 1991. Before publication of this manual, there were no authorized wind resistant manuals which can be...
Bridge Aerodynamics and Response Control?Recent Research and Developments in Japan
Bridge aerodynamics and its response control with emphasis on the recent R/D in Japan are reviewed. Aerodynamic countermeasures based on the vibration mechanisms as well as mechanical...
Return to search