High-speed Video Analysis of Sediment-Turbulence Interaction
Results from the analysis of high-speed video recordings of particle motion and simultaneous flow visualizations in the near wall region of a turbulent open channel flow are presented....

Innovative Instrumentation for a Physical Model of River Ice Transport
Large physical models often require the use of innovative instrumentation and measurement techniques. Hydraulic models that attempt to simulate the effects of stationary ice covers put...

A New Basic Principle for a New Series of Hydraulic Measurements. Erosion by Abrasion, Corrosion, Cavitation and Sediment Concentration
The DECAVER is a novel apparatus able to make new measurements in various domains where an erosion is produced in an aqueous medium. It gives the erosion rate and the accumulated erosion....

Hydrodynamic Forces in Hydraulic Jump Stilling Basins
The knowledge of hydrodynamic forces acting on hydraulic jump stilling basin slabs has been a research topic for the past four decades. Published methodologies for computing the hydrodynamic...

Instrumentation Needs and Possibilities: A Dialogue Between Suppliers and Users
The present symposium includes a panel discussion to address and illuminate needs and possibilities in hydraulic instrumentation. The panel discussion is organized with the intent of promoting...

Practical Method for Calculating Contraction Scour
Total scour at bridge crossing waterways consists of long-term aggradation or degradation of the streambed, contraction scour and local scour at the piers and abutments. This paper will...

Sensitivity Analysis of Bridge Equations
Computation of riverbed scour at the 482,000-plus bridges over water in the United States of America requires a significant level of hydraulic engineering effort. To do cost-effective,...

Damage to Highway Infrastructure 1993 Mississippi River Basin Flooding
A study has been initiated to investigate the basin-wide impact of the 1993 Mississippi River Basin flooding on damage to the highway infrastructure. The study involves site investigations...

Kent, Edward
In order to perform conservative scour analyses for coastal bridge sites it is necessary to develop realistic hydraulic simulations which provide worst case estimates of depth and velocity....

Expert Analysis in Regulated Irrigation Canal Modelling
Application of riverine unsteady-flow numerical modelling techniques to problems of flow regulation in irrigation canals invokes the need for careful treatment of some situations not commonly...

Reconstruction of Concentration Boundary Condition for Unsteady Pesticide Transport Modeling
A one-dimensional unsteady contaminant transport model which used an unsteady hydraulic field was used to model pesticides (metolachlor, metribuzin) in the Iowa River/Coralville Reservoir....

GIS Application for Floodplain Analysis and Mapping
Michael Baker Jr., Inc. (Baker) is using Geographic Information Systems (GIS) technology and fundamental three-dimensional modeling techniques to automate the floodplain analysis and mapping...

Estimation of Field Site Flow Parameters
The paper reports on the use of Kriging to obtain estimates of hydraulic conductivity underneath a rapid infiltration site. The parameters obtained were used in a two-dimensional groundwater...

An Attempt of an Aquifer Model with Lack of Data
The University of the Americas in Cholula, Puebla, Mexico withdraws water from an unconfined aquifer. Also the city of Cholula and the city of Puebla withdraw water too. A model aquifer...

Movement of Colloids Under Hydraulic Gradients
A model was developed for analyzing the movement of colloidal clay particles in laboratory soil columns. The physical mechanisms of detachment of particles from the soil matrix, their...

Probable Maximum Flood Estimation for New and Existing Dams
Although various attempts have been made to streamline the procedures to determine PMF hydrographs for the design of new and rehabilitation of existing dams, there still remains a great...

HEC River Analysis System (HEC-RAS)
The Hydrologic Engineering Center (HEC) is developing next generation software for one-dimensional river hydraulics. The HEC-RAS River Analysis System (HEC, 1994) is intended to be the...

Modeling of Maximum Velocity in Open-Channel Flow
A great deal of information about an open channel flow is contained in the maximum velocity, which, along with the entropy parameter, can determine the mean velocity. Therefore, the maximum...

Hydraulic Design of Spillway Plunge Pool Linings
The design of plunge pools for high head spillways with flip bucket terminal structures often requires a detailed examination of the stability of the resulting scour hole in the river...

Revised Hydraulic Design of the Rio Hondo Flood Control Channel
The US Army Engineer District, Los Angeles has completed a major review study of the Los Angeles County Drainage Area (US Army, 1992) and has determined that the existing flood control...

 

 

 

 

Return to search