Type Curves for a Slug Test in an Infinitely or Semi-infinitely Thick Aquifer
Type curves are provided for a slug test in an infinitely or semi-infinitely thick aquifer, the latter with the single confining layer immediately above or immediately below the well....
Aquifer Measurements at Different Scales
Multilevel slug test data from five wells in a confined, sandy aquifer were analyzed to obtain an estimate of the vertical variation of the horizontal hydraulic conductivity, K(z). Hydraulic...
Application of Tracer Tests in Groundwater Remediation Design
Recent advances in the area of field testing for the quantification of hydraulic conductivity have resulted in improved site characterization of aquifer hydraulics and greater reliability...
Stepped Spillway Design for Flow Over Embankments
Many embankment dams have been identified as unable to pass their design flows without failure due to overtopping. The U.S. Bureau of Reclamation (Reclamation) is currently at the forefront...
Modeling and Field Experiments for Tracer Gas Tests
Numerical modeling and field experiments were used to extend the tracer gas technique for determining surface gas transfer rates to shallow bays. Two-dimensional modeling was used to investigate...
Bridge Scour Vulnerability Assessment
Although the failure of the New York Throughway bridge over Schoharie Creek in 1987 has focused national attention on scour related failures, other failures reinforce the need for implementing...
Modeling of Wetland Hydrodynamics and Transport in Coastal Louisiana
Modeling of hydraulics and transport of large wetland systems poses critical decisions between resolution of the complex geometry of a wetland and the testing required to meet study goals....
Scour Measuring and Monitoring Equipment for Bridges
The National Cooperative Highway Research program (NCHRP), through the Transportation Research Board (TRB) of the National Academy of Sciences, is currently sponsoring a research effort...
Set-Down in a Tidal Embayment
A mean water level in tidal bays and estuaries that is higher than the ocean mean water level (set-up) is a fairly common occurrence. Set-down of the mean water level can be shown to be...
Experimental Model Study of Over and Under Baffles
A hydraulic model study of a chlorine mixing channel was conducted at the Hydraulic Research Laboratory of the City of Los Angeles. An arrangement of over-under baffles was used to facilitate...
Ultrasonic Velocity Meter Used in Stream Gaging
Many streams and canals in Florida are affected by tides or control structures and experience very low flow velocities at times. For example, the St. Johns River in northeastern Florida...
Computerized Hydraulic Modeling?A Case Study
A hydraulic model study is being conducted at the Alden Research Laboratory, Inc. (ARL), to study the effects of adding a hydroelectric generating station at the site of an existing lock...
Detecting the Twin Vortex Draft Tube Surge
Experiments were performed to investigate a twin vortex draft tube surge in a homologous model and the prototype 700-MW turbines installed at the U.S. Bureau of Reclamation's...
Probabilistic Aspects of Hydroproject Maintenance
A survey of operation and maintenance personnel in the hydraulic structures sector was conducted to learn about the present maintenance approach and the perception of the probabilistic...
Model Studies on Local Scour
In this investigation, the scaling procedure of a scour model in the laboratory has been indicated. The results have been compared with the prototype data....
Who Pays for the Unexpected in Construction
The problem of who pays for the unexpected in construction is discussed in relation to the testing and inspection of construction materials. Laboratory is often blamed for poor construction...
Laboratory and Field Research in Construction Automation
This paper presents a series of research projects to build and test prototype systems. It has been found that prototyping provides an economical approach to support both basic and applied...
Construction Inspection Responsibility from the Viewpoint of a General Contractor and Construction Manager on a GMP Project
Absent local laws to the contrary, any member of the construction team, the Owner, Architect, or Contractor, can theoretically arrange for and provide any testing and inspection that may...
Seismic Design Issues for Immersed Tube Tunnels
This paper provides an overview of the issues and the state of the art techniques in the seismic design of immersed tube tunnels (ITT). Particular focus is given to the ITT presently planned...
Effect of Temperature on Gas Transfer at Low Surface Renewal Rates
In order to investigate the dependence of gas transfer coefficients on temperature under conditions of low surface renewal rates, laboratory experiments were conducted using simultaneous...
Return to search