Stability Analysis of Optimal Active Control Systems with Time-Delay and Other Influence Parameters
This paper presents a theoretical solution for determining the stability region of multi-story buildings equipped with one active tendon controller on a certain floor. In this theoretical...
Digital Signal Processing Techniques for Active Structural Control
In the past, implementation of active structural control strategies employing PC-based hardware has been problematic due to excessive computational times required for processing the measured...
Generalized Optimal Active Control with Embedded and Half-space Soil-Structure Interaction
The paper presents an optimal active control algorithm with soil-structure interaction for seismic response. By using an intelligent device in the feedback gain matrix, the algorithm can...
Modal Filter Based Structural Control of a Highway Bridge
An Adaptive Modal Filter (AMF) algorithm is developed which uncouples complicated multi-mode structural dynamic response into simple single-mode response. The application to active structural...
Computing in Analysis and Design in Structural Engineering Education, Practice and Registration - A Rationale for Dialogue
Structural analysis and design are increasingly being taught using personal computers, workstations or mainframe computers at the universities. The structural engineering designs in small...
Computing in Analysis and Design in Structural Engineering - An Educator's Point of View
The use of the computer in structural engineering education is discussed. It is emphasized that the students must have an understanding of both the analysis process and the behavior of...
Computing and Design in Structural Engineering A Practicing Engineer's Point of View
The development of the electronic computational power of the computer has been a boon to the structural engineering profession. The resulting increases in the speed and efficiency of the...
Computing in Analysis and Design in Structural Engineering Education, Practice and Registration: A View from the National Council of Examiners for Engineering and Surveying
When taking the examinations for licensure as professional engineers, computers are not allowed. The knowledge tested on the Structural Engineering examinations are discussed with a sample...
Validation of a Continental-Scale Storm Surge Model for the Coast of Delaware
Coastal structures are designed to provide protection against various forces of nature acting in the coastal zone. Structures such as seawalls are expected to provide onshore protection...
Localized Sigma Coordinates for the Vertical Structure of Hydrodynamic Models
This paper analyzes the use of localized sigma coordinates in the numerical solution of the vertical structure of coastal flows. We show, through a combination of truncation error analysis...
Design, Construction, and Maintenance of Relief Wells
Technical Engineering and Design Guides, as adapted from the U.S. Army Corps of Engineers, No. 3 This engineering manual provides guidance and information...
Boston's Backup Water Supply
For fifty years, Boston's sole real source of water has been the Hultman Aqueduct, but now final design is almost complete on the MetroWest Supply Tunnel, a new, larger conduit...
An Experimental and Analytical Study of the Shoreline Response to Non-Parallel Breakwaters in Oblique Waves
REsults of an experimental and analysis study single breakwaters on oblique waves are presented. Three orientations of the breakwaters are studied, those being parallel to the shoreline,...
Wave Run-Up and Reflection on a Permeable Sea Wall
The swash oscillation on a sloping seawall made of step-shaped concrete blocks, waves and water particle velocity in front of the seawall were measured. It was inferred that incident waves...
Wave Transformation and Load Reduction Using a Small Tandem Reef Breakwater ? Physical Model Tests
The performance of several small reef breakwaters, and a tandem breakwater system (consisting of a reef breakwater positioned upwave from a surface-piercing main breakwater), are quantified...
The Evolution of Breakwater Design
The purpose of this paper is to present a view of the evolution of both the rubble mound and vertical faced breakwaters from the earliest design through the Iribarren and Hudson era. Determining...
Dynamic Loading of Airfield Pavements Caused by Aircraft Operations on Rough Runways
This paper presents results for dynamic pavement loading of various aircraft under takeoff and taxing scenarios. The data were obtained from computer simulation and applied to the Corps...
Implementation of Elastic Layered Theory for Design of Unbonded Overlays
The U.S. Army and Air Force have implemented the elastic layered theory for design of unbonded overlays for rigid airfield pavements. The procedure allows for design of unbonded overlays...
The Use of Crumb Rubber Modifier in Hot-Mix Asphalt
This paper summarizes the literature on the use of CRM as an additive in HMA. Wet and dry processes are discussed and the objective of each explained. Material, design and construction...
Utilization of Phosphogypsum-Based Slag Aggregate in Portland Cement and Asphaltic Concrete Mixtures
This study centers around the potential utilization of phosphogypsum-based slag aggregate as a substitute for coarse aggregate in both portland cement and asphaltic concrete surfaces for...
Return to search