A Stochastic Source Spectrum for Engineering Application
The solution of a point source (double couple) combined with K. Aki/A. S. Papageorgiou's stochastic source model is used to establish the power spectrum at the acceleration...
Structural Dynamics in Hurricanes and Tornadoes
The random fluctuations of wind gusts produce dynamic interaction with structures. The objectives of this paper are to identify distinguishing differences in hurricane and tornado winds...
Dynamic Response Correlation Using Simplified Models
A simplified model for building response which has a W. Ramberg-W. R. Osgood hysteresis is developed in a discrete sense. It is then used to evaluate the response of an instrumented, bearing...
Performance of an Earthquake Excited Roof Diaphragm
The objective of this paper is to study the earthquake performance of the roof diaphragm of the West Valley College gymnasium in Saratoga, California through a complete set of acceleration...
Experimental Studies, Structural Design and Full-Scale Measurements for the Columbia Seafirst Center
The Columbia Seafirst Center is a 76-story office tower located in downtown Seattle, Washington. It rises to a height of about 940 feet above ground and is the world's 10th...
Comparison of Predicted and Measured Dynamic Behavior of Allied Bank Plaza
Structural engineering aspects of a monitoring program to measure Allied Bank Plaza tower's dynamic response to wind are presented. In particular, field data developed during...
Design of Viscoelastic Dampers for Columbia Center Building
To reduce the dynamic response of a building with a given height and plan area to wind load, aside from inherent damping of the building, the designer has a few options available to him/her....
Performance of Viscoelastic Structural Dampers for the Columbia Center Building
Vibratory motion of structures such as buildings, bridges, and floors can be reduced by the use of viscoelastic (V. E. ) dampers. Such dampers transfer part of the vibratory energy of...
Complex Tower Meets Quake Code
A Los Angeles building consists of a triangular 23-story office tower stacked on top of an 11-story rectangular parking garage. The dual-shape is unique in seismically active southern...
Design Concepts for Floating Breakwaters
This paper describes a fundamental approach to the design of a floating breakwater based on the concepts of dynamic analysis of floating bodies. The process results in a relatively simple...
Recent Advances in Structural Dynamics
The four papers in this book emphasize the design, testing, and analysis of large structures. The topics covered include base isolation in the design and construction of power plant structures,...
Dynamic Response of Structures
The primary goal of the third specialty conference on the dynamics of structures was to provide a forum for dialogue between engineers conducting experimental tests and those developing...
Building Motion in Wind
The trend towards higher structural efficiency and hence lower cost has resulted in a generation of lighter and more flexible buildings with a lower inherent capacity for energy dissipation...
Terzaghi Lectures
1974-1982
Sponsored by the Executive Committee of the Geotechnical Engineering Division of ASCE. This Geotechnical Special Publication contains eight lectures...
In Situ Tests Aid Design of a Cylinder Pile Wall
In situ testing was used to verify geotechnical design parameters and modify construction for a 22 million dollar slope stabilization project near a major highway interchange. The project...
Correlation of Soil Parameters From In Situ and Laboratory Tests for Building 333
Pressuremeter, plate bearing and cone penetration tests were performed on the prepared foundation soil for Building 333 located in the Red River Army Depot near Texarkana, TX. The results...
Dilatometer Tests in Sand
The paper presents two applications of the dilatometer test in sands: control of compaction and determination of constrained modulus. Twelve dilatometer tests were carried out before and...
A Relationship Between Deformation Modulus and SPT N for Gravels
The results of over 200 horizontal plate load tests performed in situ in large diameter boreholes on gravels at various relative densities are used to develop a relationship between deformation...
In Situ Tests for Foundation Vibrations
There are several well established methods of determining shear modulus in situ and these are summarized in this paper. New techniques are being developed for in situ determination of...
Dilatometer to Compute Foundation Settlement
Sixteen examples demonstrate how the S. Marchetti dilatometer test (DMT) provides soil compressibility data for the rapid calculation of foundation settlements with an average ratio of...
Return to search