The Construction Engineer, Bureau of Reclamation
The Construction Engineer's responsibility for the Bureau of Reclamation covers, staffing, contract administration, design data collection, funding, claims, and supervision...

The Resident Engineer's Role in Multiple Contracts
This paper addresses the role of the Resident Engineer who functions either as a General, Electrical, Mechanical or Mechanization Engineer in multiple prime construction contracts. By...

The Resident Engineer as a Communicator
Communication is an important part of the Resident Engineer's job of Contract Administration. This article focuses on the problems facing the Resident Engineer in communicating...

Challenge to the Resident Engineer
This paper examines that which makes a good engineer, whether or not the contract language plays a part in his effective performance, personality traits, and if there exists a proper contract-resident...

Can We Save the Ogallala?
The useful life of the Ogallala Aquifer, which underlies seven western states, can be extended indefinitely through water conservation in the widest sense of the term. In addition to optimization...

Hydropower's Newest Generation
Higher energy prices and strong incentives from the federal government have caused hydropower developers to consider sites that just a few years ago were scoffed at as mere trickles. Intense...

Two Projects Became One
Nontraditional funding and a new law were required before two Cortez, Colo. projects could be combined. Building a new canal and enlarging and lining an existing one to move water in essentially...

Blind Drilling Down Under
Australia's largest blind drilled shaft is a 14 ft diameter fresh air shaft for the Agnew nickel mine 500 miles northeast of Perth. It was drilled in one pass using air-assisted...

Drainage Tunnels Save Freeway Link
A 15 mile section through downtown Phoenix will complete Interstate 10. After years of delay, the project is now close to completion. The project required construction of 6.5 miles of...

Resource Allocation with Project Manager Control
There are some logical reasons behind the partial acceptance of the resource allocation research by the construction industry. These reasons are based on field experience and the daily...

Modeling Construction Companies
This paper reports on the development, implementation, and practical use of a micro-computer based system which simulates the organizational performance of construction companies. The...

Decision Support System for Tunneling
This paper first discusses methodologies for considering geological uncertainty in tunneling projects and for determining the most economic excavation and support methods under such condition;...

Avoiding Disputes Through Better Management Techniques: A Contractor's Viewpoint
Utilizing management techniques to avoid disputes is an important function which allows resources to be focused on the project objectives. Relationships are enhanced, cost are reduced,...

Avoiding Contractor Disputes During Project Design
The New Jersey Transit Corporation is in the second phase of a billion dollar rebuilding program of its rail system. The first phase, which featured electrification and signal system replacement,...

Avoiding Disputes: The Construction Manager's View
Avoiding and minimizing contract disputes, from the construction manager's (CM) point of view, begins during the preliminary planning and design stages and continues throughout...

Proper Specifying with the Or Equal Clause
'Or Equal' product specifications are the subject of this paper and shown to be frequently involved in quite serious contract disputes. Management strategies...

Constructibility Review of Documents Before Bidding
Many claims have their inception at the very beginning of a project, specifically at the time of bidding. Contractors review the Contract Documents prior to bidding. The way in which they...

Specification Deficiencies?Contract Disputes
The costs of rework, replacement, duplication, delays, and related administration are major factors in disputes. The major reasons for specification-caused disputes are discussed. A three...

Better Design Documents Through Constructibility Review
The Corps of Engineers (Corps) improves the quality of design documents by an extensive program to review in-house and Architect/Engineer (A/E) designs. This review is composed of several...

Construction Inspection?The Last Line of Defense
Construction inspection, or a quality assurance program, is typically the last line of defense in relation to claims for the constructed project. The quality assurance team should be a...

 

 

 

 

Return to search