Failure Modeling of Hydraulic Systems
Techniques of survival analysis are investigated for modeling the failure of hydraulic systems. The Proportional Hazards Model has the advantage of being able to separate the effects on...
Stability Criteria for Revetments
A simplified 'black box' approach is presented for a number of revetment systems for banks and shore protection. The design criteria, based on the physical similarity...
Physical Modelling of Self Forming Alluvial Channels
A method is presented for the determination of a practicable physical model of self-forming channels in cohesionless alluvium. Both sand bed and gravel bed regime channels are considered....
Modification to John H. Overton Lock and Dam
The Red River Waterway Project, Mississippi River to Shreveport, Louisiana, will consist of a navigation channel 9 feet (2.7m) deep by 200 feet (61.0m) wide, 5 locks and dams providing...
Guard Gate Tests at Tieton Dam
The emergency gate hoist system on the guard gates at Tieton Dam, near Yakima, Washington, was tested as part of the United States Bureau of Reclamation Safety Evaluation of Existing Dams...
The Sediment Weighted Histogram Generator and Estimation of Sediment Transport Trends
Long term sediment transport trends may be evaluated using a sediment histogram generator program that was written for microcomputers. Flows can be extracted directly from a compact disc...
Kinematic Wave Based Hydrologic Models with Different Solution Methods
The hydrologic simulation models RUNOFF and HEC-1 are applied to a 3212-ha watershed in New Jersey, and performances of the two models in predicting historical stromwater hydrographs from...
Paleoflood Hydrology and Design Decision for High-Risk Projects
Paleoflood hydrology is not merely one of several alternative methods for risk-based design. Rather, certain kinds of accurate data on the largest paleofloods of recent millennia provide...
Comparison of Correction Factor for Dispersion Coefficient Based on Entropy and Logarithmic Velocity Profiles
Recently, new velocity distribution equations have been developed by Chiu (1987, 1989) through the use of maximum entropy principle. A comparison will be made of the correction factor...
On the Problem of Sediment Deposition in Large Reservoirs
Sediment deposition and its accumulation in a large reservoir depends on the inflow and reservoir storage content, respectively. This fact is used to model the cumulative deposition of...
Application of the Ackers-White Procedure for Transport by Size Fractions and Testing in HEC-6
Modification of the Ackers-White method for the calculation of sediment transport by size fractions has led to a procedure which not only permits such calculations, but also increases...
Numerical Modeling of a Trench Fill and Scour
The sediment fill and scour in a dredged trench was numerically simulated by the nodal-collocation finite element method and an explicit scheme. The one-dimensional unsteady sediment-laden...
Municipal Stormwater Management Ordinance Development and Implementation in Pennsylvania
This paper discusses the critical planning and engineering components of a sound stormwater management ordinance and how they can be shaped to avoid commonly encountered basin-wide implementation...
Urban Stormwater Management Practices: Concepts and Misconceptions
A variety of methods are practiced for the management of urban stormwater runoff. These include detention basins/ponds, retention basins, infiltration basins, and seepage pits. This paper...
Evaluation of the Potential for Release of Residual Coal Tar by Flood Scour at a Superfund Site
To address the potential for release of residual coal tar by flood scour, stream cross-sections, stream discharge and sediment grain size data were collected during the Remedial Investigation...
An Expert Advisor for Selective Withdrawal Operations
A rule-based computational advisor that aids in the selection of selective withdrawal operations for project release temperature maintenance is discussed. This advisor couples a one-dimensional...
Development of a Computer Aided Decision Process for Channel Rehabilitation and Watershed Enhancement Techniques
To assist the engineer in planning and design of channel stabilization measures, an expert system (CADWET) was developed using a commercially available expert system shell program. The...
Equivalence Between Regular and Irregular Waves in Movable-Bed Models
Laboratory experiments were conducted to evaluate various irregular wave parameters to determine which provides the best match for the regular wave parameter used to develop design guidance....
Physical Forces Generated by Barge-Tow Traffic Within a Navigable Waterway
Movement of navigation traffic such as barge tows within a restricted inland waterway such as the Illinois, Mississippi, or Ohio Rivers can and will alter the flow field in and around...
Computation of Sediment Transport Resulting From Snowmelt and Rainfall in a Sierra Nevada Watershed
Erosion within a watershed can cause extensive damage to the land and adjacent properties. It is a common problem throughout the United States, and has become severe in many areas of the...
Return to search