Dynamic Loading of Airfield Pavements Caused by Aircraft Operations on Rough Runways
This paper presents results for dynamic pavement loading of various aircraft under takeoff and taxing scenarios. The data were obtained from computer simulation and applied to the Corps...

Willingness and Ability to Pay for Rural Water
Estimates of willingness to pay for rural water systems were developed in South Dakota, Oklahoma, and Montana from responses to contingent valuation surveys. Ability to pay was also estimated...

Lewis and Clark Rural Water System: A Regional Approach to Solving Domestic Water Supply Problems for a Tri-State Area
The proposed Lewis and Clark Rural Water System (L&CRWS) is a treated, bulk water delivery system. Membership includes twenty-two communities and rural water systems in southeastern...

Changing Dam Operating Criteria to Accommodate Aquatic Biological Diversity
The Colorado squawfish, bonytail chub, humpback chub, and razorback sucker, now threatened with extinction, were once the dominant fishes in the river. Recovering these native species...

Arizona Groundwater Management Alternatives
Sustainable groundwater management policies are examined through the use of a hydrologic-economic impact model of Arizona surface and groundwater use. Present water use practices were...

Prediction of Gravel Bedload with SAM
Bedload measurements for Little Beaver Creek in Colorado were used to test the sediment transport functions included in SAM. The test results showed that Toffaleti predicts total bedload...

Water and Wildlife Enhancement with Land Retirement
This case analysis compares costs of land retirement and current on-going structural improvements for salinity reduction in the Colorado River. Results suggest land retirement programs...

The Economic Cost of Stocking Catchable Rainbow Trout
States annually stock about 20 million pounds of catchable trout in public waters. Complete information on cost is essential to help wildlife agencies make operating and planning decisions....

Simulating Hourly Hydropower Operations for the Assessment of Environmental and Economic Impact
Generation of peaking power at Glen Canyon Dam causes river flow and stage to fluctuate on an hourly basis. This has been shown to impact the downstream physical and biological environment....

Hydrodiplomacy on Forester Creek
The goal of this paper is to share information regarding political battles confronting the engineer with regards to drainage issues and concerns. Very often drainage boundaries do not...

Economic Impacts of Severe and Sustained Drought
A hydrologic-economic-legal impact model shows that a severe and sustained drought in the Colorado River Basin would cause acute economic damages to most instream water users, and to upper...

Missouri River Economic Impacts Model
The Missouri River basin recently (1987-1992) experienced a drought that affected project uses and environmental resources. This drought and the need to address changes that have occurred...

Denver's Direct Potable Water Reuse Demonstration Project
The Denver Potable Water Reuse Demonstration Project was created to provide definitive answers to the interrelated questions of product quality, public health, technical and economic feasibility,...

Missouri River Recreation Economic Analysis
The Missouri River main stem lakes and downstream river reaches encompass about 1900 river miles from the mouth at St. Louis, Missouri, to the headwaters of Fort Peck Lake in Montana....

Opportunities, Constraints and Change in Reservoir Management
Changing hydrologic, economic, social and environmental conditions have focused attention on the opportunities for changing reservoir management. Such change can occur in three areas....

Concrete Watertight Structures and Hazardous Liquid Containment
The purpose of Concrete Watertight Structures and Hazardous Liquid Containment is to provide a practical guide for practicing engineers who...

Retaining and Flood Walls
The engineering manual Retaining and Flood Walls from the U.S. Army Corps of Engineers provides guidance for the safe design and economical...

Circle Integration
Based on the results of proof-of-concept experiments, we propose that an integrated suite of software tools can support both automation and integration of several components of AEC design...

FEM in a Design Code Environment
The results obtained from the use of finite element based analysis tools have created a new problem for designer: Which numbers do we use to check against Code limits? Most of the commonly...

A program for the Analysis of Pile Load Tests
The load capacity of piles are routinely determined from full scale pile load tests under actual field conditions. Several empirical methods were proposed for the analysis of field load/settlement...

 

 

 

 

Return to search