Analysis of Glass-Ceramic Production from Lunar Resources
Two simulated regoliths were used to investigate the effects of processing and composition on the properties of lunar-derived glass-ceramics. For the simulant with moderate iron concentration,...
An Ultra-Lightweight Advanced Technology Telescope for Space Applications
We propose a new type of telescope designed specifically for space and lunar applications. The optical reflecting surfaces of the telescope are made by replication onto thin ultra-lightweight...
A Dome For the 21st Century
Putting a circular dome on a square building--the classical architectural design challenge--takes on new proportions at the Federal Building and Courthouse in Charleston, W. Va. The 170...
Design of Mat Foundation for Egg Shape Digesters
Two levels of ground motion, the Maximum Probable Earthquake and the Maximum Credible Earthquake, were considered in designing the 2.5 million gallon egg shape digesters and their combined...
Nonlinear Collapse of Offshore Jacket Structures
The Joint Industry Tubular Frames Project was established with ten oil industry sponsors to investigate the reserve and residual strength of frames typical of offshore structures. To date...
High-Strength Concrete Columns in High-Rise Buildings
Strength and ductility of high-strength concrete columns were investigated by examining available test data. The results are summarized in terms of load and ductility capacities of columns....
Lateral Bracing Criteria of the Composite Braces
In order to simplify the hysteretic characteristics of diagonal steel braces, a lateral bracing problem of unbonded braces embedded in the concrete panel is treated here. Lateral bracing...
Shock-tested R. C. Slabs: Significant Parameters
Shock-tube tests of plain concrete and reinforced concrete (R. C.) slabs were performed. The influence of free water in concrete pores, emphasized in previous tests at a material level,...
Load Rate Effects on Concrete Compressive Strength
Plain concrete cylindrical specimens from six different concrete mixes, 51 mm in length and diameter, were tested in compression quasi-statically at strain rates between 10-6/sec...
Impulsive Punching of Fiber-Reinforced Concrete Slabs
The behavior of FRC slabs reinforced with polymeric fibers (polyacrylonitrile fibers PAN) and subjected to impulsive punching is analyzed here in order to clarify to what extent the fibers...
Monitoring of Structures During Repair of Underground Utilities
A collapse of underground utilities at a power plant required the constant monitoring of the surrounding structures during excavation and replacement of the damaged pipes. A computer-based...
Innovative Design of Steel Gable Frames
Common wisdom holds that conventionally designed gable frames fabricated from rolled sections cannot compete with metal building system frames fabricated from plate and bar stock, from...
FRP Box-Beams Under Long-Time Static and Fatigue Loading
This paper discusses experimental and analytical aspects of the long-time behavior of filament wound E-glass fiber reinforced epoxy-box-beams. Theoretical and experimental data are compared...
Rational Limits for Longitudinal Steel in Concrete Columns
Current limits for the amount of longitudinal reinforcement in concrete columns were established more than 60 years ago. Commercial grades of reinforcement in 1930 were about half as strong...
High-Strength Concrete Columns: State of the Knowledge
This paper consists of reported information divided into two general categories, performance of High-Strength Concrete (HSC) columns under concentric loads, and combined axial and bending...
Evaluation of Wood Floor Vibration Design Criteria
In the United States, floors in wood buildings are designed according to strength and deflection criteria under static uniform loads. With the introduction of engineered joist products...
Strength Variability of Wood Formwork Members
Failure of concrete formwork is one of the main causes of concrete construction failures. Among the main causes of formwork failure is inadequate strength. Currently there is no published...
Design Guidelines for the Use of Debonded Strands
In this paper, presented are the flexural tests performed on beams containing debonded strands. Results show that debonded strands can be used reliably and safely, stipulating that the...
Development Length of Uncoated Prestressing Strand
The Federal Highway Administration is conducting ongoing research which investigates the development length of uncoated and epoxy coated prestressing strand in prestressed concrete members....
Mechanical Behavior of Dowels Embedded in Concrete
In this paper an experimental investigation on the behavior of dowels embedded in concrete is described. The dowel strength under monotonic forces with two different boundary conditions...
Return to search