A Model of Flow in Regulated Open Channel Networks
A model (NETWORK) is presented for the simulation of unsteady flow in regulated open channel networks. The operation of hydraulic structures, such as gates and weirs, are simulated as...
Channel Response to SCS Type-C Grade-Control Structures on Burney Branch, Mississippi
Five SCS Type-C grade-control structures were installed in Burney Branch in 1980 to remove 59.4 feet (18.1 m) of grade. The performance of the structures was evaluated in 1984 after they...
Analysis of Spillway Failures by Uplift Pressure
Results of a model study to evaluate the development of uplift pressures beneath concrete chutes are presented. Two spillway failures are described to support the study results. Common...
Design and Performance of Earth Spillways
The U.S. Department of Agriculture's Soil Conservation Service has designed and administered construction of a large number of dams utilizing grassed earth-lined auxiliary...
Mathematical Model of Wave Induced Pressures
A two-dimensional, implicit finite difference model was built to compute surface wave induced pressures under a gravity base foundation. The results showed considerable wave attenuation...
Performance Evaluation of Channels Stabilized with ARS-Type Low-Drop Structures
Field and hydraulic investigations of seven ARS-type low-drop grade-control structures located in Mississippi indicate that most of the structures become submerged during flows with recurrence...
Gas Transfer at Hydraulic Structures
Field measurements of gas transfer at hydraulic structures are notoriously difficult and imprecise. A technique which measures the transfer of hydrocarbon tracer gases has been tested...
Dam Safety, Yes.; But What About Safety at Dams?
Design and construction of safe structures are the professional obligations of hydraulic engineers. However, there are environmental dangers with safe structures which engineers often...
Drag Characteristics of Spheres in Bingham Fluids
R.W. Ansley and T.N. Smith's type of drag relation can be traced back closely, if not completely, to the Newtonian drag curve. The equivalent diameter for a sphere in a Bingham...
Hydraulic Effects on Swimming Fish in Fish Passage Structures
The implications of profile drag, weight, and buoyant forces on energy and power requirements of fish swimming through fish passage structures are considered. Where hydraulic grade lines...
Flow Through Fish Bypass Intakes
Hydraulic and computational fluid dynamic models were used to investigate the cause of the unequal intake flow distribution observed entering the three vertical intakes of the patented...
Physical Model of Local Scour at Grade Control Structures
A physical model of local scour occurring at grade-control structures was operated at an undistorted Froude number prototype-model scale ratio of 1:4. The maximum unit discharge in the...
Design of Riprapped Scour Holes for Flip Bucket and Overfall Spillways
Presented in this paper is a simple method of predicting pre-excavated scour depths and geometry for riprapped basins below flip bucket spillways. The input data needed for establishing...
A Numerical Solution Technique for Incompressible Flow
Presented is a numerical solution technique which employs the explicit predictor-corrector scheme of R.W. MacCormack in solving the governing two-dimensional equations of motion on a staggered...
An Error Analysis of the Dynamic Wave Model
The Dynamic Wave Operational Model (DWOPER) is used to forecast river stages on the Lower Columbia River. DWOPER was developed by the National Weather Service's Hydrologic...
Terrestrial Trends for Building Technology in North America
This paper discusses new building technologies that will develop in the early 1990's to become significant technologies by the mid 1990's. The perspective is...
Concrete Lunar Base Investigation
Scientific and industrial operations on the moon require suitably shielded structures. Small structures for limited scientific activities may be constructed from structural elements prefabricated...
Lunar Cements/Concretes for Orbital Structures
The lunar surface is a rich source of inorganic building materials for large space structures. Lunar anorthosites can be processed into calcium aluminate cements in high temperature, high...
Concrete Habitable Structure on the Moon
This paper presents construction methods for a concrete habitable structure on the Moon. The study was conducted on the assumption that a concrete manufacturing plant has already been...
Construction Operations for an Early Lunar Base
Construction and excavation operations performed during the earliest stages of a manned lunar base pose a unique set of problems. This paper will describe six construction tasks that are...
Return to search