Experimental Determination of Fluid-Coupling Coefficients in an Array of Hexagonal Prisms
The problem is related to the seismic analysis of fast breeder reactor cores, where the fluid trapped between the subassemblies is known to have a considerable influence on the core response....
Update on Impact Effects in Nuclear Plants Part II?Review of Pipe Whip Impact
Current regulations require that pipe breaks be postulated in high-energy lines and measures be taken to prevent consequent damage to essential structures and systems. The paper addressed...
Computer-Automated Limit-States-Design of Steel Frameworks
The paper concerns the computer-automated synthesis of minimum-weight planar steel frameworks. For any number of applied loading cases, the design of the structure may be constrained by...
Reliability-Based LRFD for Transmission Structures
A simple reliability-based Load and Resistance Factor Design (LRFD) method is proposed for the structural design of electric transmission lines. With the proposed method, the designer...
Plastic Design Requirements of the AISC Proposed LRFD Specification
The American Institute of Steel Construction proposed LRFD Specification (1) has recently completed a one year period of trial use and review. This paper discusses the background of the...
Engineering Mechanics in Civil Engineering
The principles of engineering mechanics and the application of these principles to civil engineering problems cover a broad spectrum of topics ranging from theory to practice. These proceedings...
Finite-Strain Axial Analysis of Piles in Clay
In the late 1970's, a series of research projects developed simple effective-stress methods to predict the axial capacity of piles in normally-consolidated clay. The method...
Centrifugal Modeling of Pile Foundations
Modeling of pile foundations in a centrifuge, where the self weight induced stresses in the soil are simulated by elevated gravity loading, is described. Hollow pipe piles in a stiff clay...
Prediction of Settlement of Single Piles in Clay
Analyses by trial were used to fit theoretical load-settlement curves to measured curves for driven piles. For the elastic method, analyses of load tests indicated that designers should...
Shaft Capacity of Driven Pipe Piles in Clay
A compilation of axial load test records for driven pipe piles in clay published by the American Petroleum Institute is analysed to yield new criteria for skin friction and pile scale...
Limiting Tip and Side Resistance: Fact or Fallacy?
The tip and side resistances of deep foundations do not reach a limit at a critical depth; instead, they increase with depth. For the tip, the rate of increase decreases with depth. For...
Cyclic Degradation of Pile Performance in Calcareous Soils
Laboratory data on the skin friction of jacked or driven model piles is presented. Significant cyclic degradation of skin friction commences when the cyclic displacement amplitude reaches...
Residual Stresses in Piles and the Wave Equation
A data base of 18 vertical load tests on driven piles in sand is presented. On average the residual point load was 56% of the measured point load and the residual friction load 19% of...
Compression Load Tests on Concrete Piles in Alluvium
A series of tests was accomplished during the design phase for the West Seattle Freeway Bridge Replacement project. The results of instrumented compression load tests in alluvial deposits...
Vertical Behavior of Two 16-Year Old Drilled Shafts
Vertical load tests were performed on drilled shafts subject to lateral confining and heaving pressures from expansive soil over 16 years. Results indicated mobilized skin friction equal...
Evaluation of P-Y Relationships in Cohesionless Soils
Four semi-empirical procedures for construction of p-y curves in cohesionless soils were developed to fit data from a particular load test or a specific set of tests on similar soils....
Evaluation of P-Y Relationships in Cohesive Soils
The practice of analyzing laterally loaded driven and bored piles often requires modeling of soil response in terms of uncoupled, non-linear unit load transfer functions. These functions,...
Lateral Load Tests of Piles in Sloping Rock Fill
A new container wharf constructed at the Port of Los Angeles features vertical prestressed concrete piles to provide both vertical and lateral support. A rockfill embankment used to allow...
Pile Caps Subjected to Lateral Loads
This paper reviews current pile cap design practices and presents results of tests on two pile caps with different reinforcement locations. Lateral load tests performed on two pile cap...
Winkler Soil Model for Axial Response Analysis of Pile Groups
In this approach, the soil is idealized as a nonlinear Winkler model for a pile group attached to a group of piles. The model can account for pile-soil-pile interaction. Pile group responses...
Return to search