Characteristics of the Flood Release-Induced Vibrations with Qianshui Thin-Arch Dam
In this article the prototype observations and design analyses are described regarding the flood release-induced vibrations of the Qianshui thin-arch dam and its foundation; and their...
Development of a Computer Aided Decision Process for Channel Rehabilitation and Watershed Enhancement Techniques
To assist the engineer in planning and design of channel stabilization measures, an expert system (CADWET) was developed using a commercially available expert system shell program. The...
Pump Selection Program and a Better User Interface
Numerous highly innovative computer solutions to engineering problems are of little use to the practicing engineer because these programs are not supported by adequate user interface....
Comparison of Flush and Chamber Mounted Dynamic Pressure Transducer
Modeling of hydraulic structures often includes the measurement of dynamic pressure fluctuations. The accuracy of the pressure measurements depends upon the geometry of the tap. Flush...
Redondo Beach King Harbor Model Studies, California
Redondo Beach King Harbor frequently experiences damage when large winter waves occur in conjunction with high water levels. Damages consist of revetment failure, land erosion, flooding,...
Low-Head Drop Structure Hazards: Modeling of an Abrupt Drop Boat Chute
Low-head drop structures are dangerous for navigational and recreational boating in rivers. In an effort to reduce drowning hazards at low-head river drop structures, a boat chute bypass,...
Cumulative Impacts Analysis on a Midwest Fluvial System
The US Army Corps of Engineers recently completed an analysis of the cumulative impacts of erosion control structures on the Platte River in Nebraska. This was done in response to concerns...
Effects of Low Drop Grade Control Structure on Bed and Bank Stability
The channel response upstream of a low drop grade control structure was documented using field investigations, analysis of the engineering properties of bank materials, and repeat cross...
Stabilization of an Alluvial Channel in an Urbanized Area
Grade stabilization structures have been used for many years to control degradation of alluvial stream in the southwest. These structures result in reducing the gradient of the stream...
Mechanical Aspects of Intake Gates at John Hart Dam
As part of the John Hart Dam rehabilitation program completed in 1988, six new intake gates complete with guides and hydraulic operators were installed replacing the existing gates and...
Model Tests for Design of Vibration-Free Gates
Experimental results are presented of hydraulic forces acting on an underflow gate. Underflow gate is a socalled bluff body and a review of the mechanism of vibration caused by separation...
Landfill Liner Quality
Landfill liners are being made with new synthetic materials, materials which may be beyond the knowledge of the engineer in charge of the landfill construction project. Engineers need...
Field Verification Experiment of a Wave Power Extracting Caisson Breakwater
The Ministry of Transport in Japan is conducting a field verification experiment of a wave power converter with a vertical breakwater called the wave power extracting caisson breakwater....
Pre-Experiments of OTEC Experimental Facility for Ocean-Based Mariculture-OTEC Pilot Plant Houyou
The ocean-based mariculture-OTEC pilot plant 'HOUYOU' was completed in March, 1989 and the at-sea test in Toyama Bay was carried out from July 18th until September...
Availability of Portland Cement
A general description of economic, technical, and environmental factors that affect the types of portland cement available is presented. Economic factors have had a major effect on balance...
The Future of Steel Structures
The future availability of steel as a construction material is covered in this paper. The advances in the material, design fabrication and erection are discussed. The quality and quantity...
Structural Wood Products
This paper provides a description of available structural wood products. Traditional products such as lumber and plywood are being supplemented by new products that include composite lumber...
Large Stone Hot Mix Asphalt: State of the Art
Improved mix characteristics can be achieved by utilizing existing well-known technologies. Developments have included: more attention to voids in mineral aggregate criteria; adjusting...
Large Stone Mixes Make a Comeback
Large stone hot mix asphalt common at the turn of the century, is making a comeback in popularity in hot mix asphalt design. Large stone hot asphalt mixtures are being used as a way to...
Comparative Evaluation of 4-Inch and 6-Inch Diameter Specimens for Testing Large Stone Asphalt Mixes
Modified Marshall equipment and Gyratory Testing Machine (GTM) are now available for compacting and testing 6-inch diameter specimens to accommodate aggregate up to 2-inch maximum size....
Return to search