The Challenge of Yucca Mountain
Yucca Mountain is the most likely site for the nation's high level nuclear wastes. Congress chose the site out of three candidates for further study before designating it...
Ductility and Failure Characteristics of Concrete and Rock Subjected to Complex Load Paths
Strength, ductility and the complex material response features of concrete and rock should be evaluated through carefully planned material properties test programs designed to subject...
Design and Construction of Stone Column Reinforced Cofferdams
A recent expansion of the North Carolina State Port Facility, at Wilmington, involved the use of six cellular cofferdams as earth retaining structures during dredging and final filling...
Settlement Characteristics from Insitu Tests in Flyash Structural Fills
Flyash from the Baltimore Gas and Electric Company's plants was used to construct structural fills in thickness ranging from 5 to 25 feet (1.5m to 7.6m). Several warehouses...
Concrete Removal Techniques with Potential for Use in Rock
This paper describes concrete removal techniques that were employed in the rehabilitation of US Army Corps of Engineers mass concrete structures and are thought to have potential for limited...
Rock Excavation with Boom Mounted Hydraulic Impact Hammers
A hydraulic demolition hammer mounted on a common backhoe or excavator carrier has gained world wide acceptance in the construction industry as a viable alternative to blasting. This paper...
Rock Excavations in Downtown Toronto
The geology of Toronto area is somewhat complex due to the series of advances and retreats of the glaciers. The overburden deposits consist of materials laid down during the Wisconsinan...
Fracturing of Rock Using Expansive Soundless Chemical Demolition Agents
The theoretical principles of the action of expansive soundless chemical demolition agents are presented. The procedure for using these demolition agents are briefly outlined. Differences...
Rock Excavation with Microwaves: A Literature Review
Research on the use of microwaves for breaking rocks started in the late fifties. In this paper, the principles of microwave heating and the possible mechanisms responsible for the breaking...
Settlement of Strip Foundations on Regularly Jointed Rock Masses
The analysis of a long, rigid strip foundation resting on the surface of a regularly jointed rock mass is presented. Two models of the overall rock mass are investigated; one in which...
New Design Method for Drilled Shafts from Common Soil and Rock Tests
A method is presented by which the compressive capacity and load-settlement characteristics of large drilled shafts can be computed from commonly executed soil and rock tests. The method...
Performance of High Capacity Caissons Founded on Decomposed Rock
The results of six load tests on large diameter caissons founded on decomposed rock are presented and analyzed. The caissons ranged from 1.5 m to 2.5 m in diameter and were 20 m to 23...
Skin Friction Load Test for Caissons in Residual Soils
Results of a load test on a drilled pier are presented. The test was performed to measure only skin friction of a 36 inch (0.91 m) diameter shaft without support at the end. The load test...
Geophysical and Nuclear Methods for Non-Destructive Evaluation of Caissons
Non-destructive testing techniques were used to confirm the concrete integrity on the caisson foundations for the 45-story Ohio Corporate Headquarters building in Cleveland, Ohio. The...
Pile-Drilled Caisson Combination for Foundation of High Rise Building
The analysis and evaluation of several alternatives for foundations of a high rise office building is presented, which resulted in the selection of a combination of high capacity piles...
Analysis of Drilled Shafts in a Deep Fill
A deep fill of varying thickness will settle with time and will also exhibit a horizontal component of movement. Drilled shafts that are installed in the fill to support a structure must...
Presented in 3-D
Stone & Webster started development in 1985 on a mainframe based computer system that provides the capability to integrate all plant information into a single integrated plant...
The CADD Landfill
Designing landfills with CADD, engineers have reduced cut and fill calculations from two weeks to two days. Aerial surveys arrive on magnetic tapes and are loaded into computers by in-house...
Computer Networking Needs in Engineering Technology
This paper deals with the planning and implementation of a local area network at the University of Arkansas at Little Rock in the new $13 million Engineering Technology and Applied Science...
Model Study of Side Slope Riprap
Laboratory experiments were conducted in 10-m long channels having 1.5 H : 1 V side slopes protected with a 20.7-mm diameter rock layer 1.5 diameters thick. Four models were tested. In...
Return to search