Erosion of the Nile Delta Coast
The construction of the High Aswan Dam has resulted in a total absence of River Nile flow into the Mediterranean, and a corresponding loss of the sediment source for the Delta. However,...
A Carrying Capacity Study of Hatteras Island
This article summarizes a study done of Hatteras Island, North Carolina, a largely undeveloped and natural barrier island. 'Carrying capacity' means the ability...
The Statistics of Storm-Induced Sediment Resuspension
The passage of a storm increases the wind stress applied to the sea surface. This surface stress is partially dissipated as it is transmitted through the water column. Some fraction of...
Effects of Dune Stabilization in North Carolina
This study analyzes changes occurring between 1937 and 1977 in the beach/dune complex along the Outer Banks of North Carolina due to the construction of a barrier dune system. Data for...
Analysis of a Coastal Embayment: Holly Pond, Connecticut
A project to restore the quality of a degraded embayment was initiated as a result of public demands, available grant funding and an ability to obtain a broad range of professional assistance...
Staggered Truss Adapted to High Rise
The 34-floor Nashville Convention Center Hotel required a structural system that would overcome the tendency to vibrate in the wind. The solution was a modified staggered frame truss,...
Hydraulic Fill Dam Made Earthquake Resistant
San Pablo Dam, near the San Andreas fault, constructed in 1919-21 by hydraulic fill methods, was found to be susceptible in places to liquefaction under seismic loading. The dam has been...
Tapping Deep Water Resources
Lena is the first commercial guyed tower. Its jacket is the longest ever fabricated, loaded out and launched in one piece. Lena stands in 1,000 ft deep water and has a three-level oil...
Project Mixes Oil and Water
The Prudhoe Bay Seawater Treatment Plant was nominated for an OCEA award, for its potential to coax from Alaska's north slope 1 billion barrels of oil which otherwise would...
Clay Pipe Installation?Advances in Load Factors
This report presents an evaluation of traditional load factor values for clay pipe and the development of a new bedding system which gives a higher load factor. Tests demonstrate that...
Failure of a Large Reinforced Concrete Pipeline
This paper describes the damage that occurred when a landslide overloaded an 11 ft diameter reinforced concrete pipeline. The 8 ft lengths of pipe, each of 11. 5-in. wall thickness, were...
Stress-Intensification Factor and Flexibility Factor in Seismic Analysis of Continuous Buried Pipelines
The topics of intensified stresses and increased flexibility in pipe bends subjected to bending loads are discussed in this paper. Also discussed are dynamic strain compatibility between...
Long Term Deflection of Buried Plastic Sewer Pipes
During the 70's and the early 80's a research program has been carried out in Sweden regarding the long term behaviour of buried plastic pipes. The program has...
Dynamics of Buried Pipelines
Forced motion of pipelines due to stationary or moving loads is studied. The pipe is modeled as an elastic shell in an elastic (or viscoelastic) medium. The interaction of the shell and...
Earth Pressure and Surface Load Effects on Buried Pipelines
Rational techniques for analyzing earth pressure and surface load effects, based on finite element analysis methods, have been developed and applied extensively to the design of buried...
Long Term Testing of Centrifugally Cast Glass Fibre Reinforced Plastic Pipes (RIRP)
The paper discusses testing of pipe manufactured by centrifugal molding. The tests included external load tests, internal load, hydrostatic internal pressure, and cyclic internal pressure....
Characterization of Soil Arching Above Buried Conduits
Conventional ways of assessing the effects of soil arching over buried conduits were examined by means of finite element analyses. It was found that neither of the conventional soil arching...
KEMCOR?A Chemical and Corrosion Resistant Piping System
KEMCOR is a new underground composite pipe system designed for chemical process use in such industries which require a high degree of corrosion resistance to varying concentrations and...
Successful Use of Centrifugally Cast Glassfiber Reinforced Plastic (GRP) Pressure Pipes for Public Works in Sweden
Centrifugally cast GRP pipes were introduced in Sweden 17 years ago for industrial applications mainly as a gravity pipe. The process of pipe manufacturing as well as the pipe itself and...
Influence of Frost Action on the Load Exerted on Buried Pipe
When work was started on revising the Swedish code for concrete pipes at the end of the 70's, a research project was carried out to evaluate the risk of increased load due...
Return to search