Reliability Assessment and Reliability-Based Rating of Existing Road Bridges
A practical reliability model for the safety assessment and rating of existing R.C. bridges are developed by explicitly incorporating the degree of deterioration and damages based on available...
On the Dynamic Response of Bridges by Oscillating Vehicles on Rough Surfaces
The spectral theory is applied to the response of bridges under a Poissonian stream of vehicles moving with constant speed over the bridge. The vehicles are modeled as oscillators with...
Research on Structural System Reliability of Cable-Stayed P.C. Railway Bridge Across Hong-Shui River
This paper analyses the structural system reliability of cable-stayed bridge by using the modified all failure modes. The concept of the structural subsystem is used to help the selection...
The Nessus Software System for Probabilistic Structural Analysis
The Probabilistic Structural Analysis Methods (PSAM) project developed at SwRI integrates state-of-the-art structural analysis techniques with probability theory for the design and analysis...
Incremental Assembly Stage Concepts for Space Station Freedom: Structural Design and Verification
The design and development of the U.S./International Space Station Freedom poses extreme technical and management challenges to the NASA/industry team. A comprehensive system engineering...
System and Utilization Study of Japanese Experiment Module for International Space Station
The paper briefly reviews the overall system study of Japanese Experiment Module (JEM) which consists of Pressurized Module, Exposed Facility and Small Remote Manipulator System (RMS)....
HELP is on The Way
Hill and Davies describe current progress on the development of a Heavy Vehicle Electronic License Plate (HELP) system in the United States. The HELP system concept combines automatic...
Innovative New Drainage Pipe
Hydraulic tests on corrugated HDPE pipe with a smooth liner show that its Mannings n-value is in the range of 0.009 to 0.015 depending on the smoothness of the liners. With the smooth...
Review of PIM (Pipeline Insertion Method) Technology
The U.S. Army Construction Engineering Research Laboratory (USACERL) conducted the first demonstration of PIM (Pipeline Insertion Method, formerly Pipe Insertion Machine) technology for...
Column Separation in Pumped Pipelines
Pressure transients are common occurrences in water supply systems. Pipeline standards and design/testing techniques will normally provide sufficient protection for transmission and distribution...
Comprehensive Leak Detection Survey and Benefit/Cost Analysis
Fort Carson, Colorado was the site of a comprehensive leak detection investigation of the potable water system with the express purpose of quantifying the benefits to be derived by a military...
Valve Control to Avoid Column Separation in a Pipe
Maximum pressures in a pipeline can be reduced significantly by closing the valve in an optimal manner. Such an optimal valve closure policy may result in some situations in minimum pressures...
Stress Relaxation Characteristics of the HDPE Pipe-Soil System
All piping materials and soils are subject to viscoelastic behavior such as stress relaxation and creep. The combination of soil and pipe viscoelastic properties determine the time-dependent...
Corrosion Protection of Cast Iron and Ductile Iron Pipe, San Diego, California
This paper addresses the use of a loose unbonded plastic covering polyethylene encasement for protection of cast and ductile iron pipe in an extremely corrosive soil. The case study in...
Measured Performance and Numerical Analysis of Buried Pipe
This study shows that the behavior of a soil pipe system can be assessed by a nonlinear elasto-plastic finite element analysis. The results of numerical calculations are compared to the...
Design of Drainage Pipes Below Landfills
Drainage pipes are an essential component of landfills. Even though their embedment conditions differ substantially from those of pipes for municipal utilities near the ground surface,...
Optimal Design of Water Transmission Mains
Capital cost for constructing a water transmission main includes cost of the pipeline and its associated installation costs. Also included in the capital cost is the cost of a pump station....
Evaluation and Selection Methodology for Determination of a Preferred Pipeline Alignment
The San Diego County Water Authority (SDCWA) had need to construct a regional 108 to 72 inch (2.7 to 1.8 meter) diameter pipeline through San Diego County to increase water supply to its...
Field Experiment on Behavior of Continuous Water Main with a Miter Bend
A field experiment was conducted to investigate behaviors of a buried continuous steel water main with a 90-degree miter bend subjected to internal pressure and ground settlement. Deformations...
Museum Showcases the Future
On May 4 in Philadelphia, the Franklin Institute's new wing, called the Futures Center, will open to the public. When the institute's neoclassic main buiding...
Return to search