Nitrate and Bromide Transport Through a Vadose Zone in New Jersey
Ongoing field experiments on monitoring transport of Sodium Nitrate and Potassium Bromide in the vadose zone over a shallow groundwater table in the coastal plains of New Jersey are discussed....
Erosion Processes in Upland Areas
After a soil particle is detached and entrained, it will be transported by the surface runoff. However, depending on the eroding and transport capacities of the surface runoff, some of...
Risk Analysis as a Tool to Determine Spillway Design Capacities
Lyman Dam is an earth and rockfill structure located on the Little Colorado River approximately 11 miles south and upstream of St. Johns, Arizona. Several studies examining the safety...
Estimation of Expected Damages, Indemnification Costs and Joint Probabilities of Dam Failures
This paper describes three methods to evaluate structural options for the rehabilitation of an existing dam using the dollar-denominated risk and capital cost associated with each option...
Thermal Plumes from Staged Diffusers into a Uniform Quiescent Environment
The behavior of thermal plumes from staged multiport diffusers was investigated experimentally. The three-dimensional temperature distribution was measured by scanning thermistor rakes...
Soluble Pollutant Enrichment in Snow Covers
A mathematical model is presented to simulate enrichment of soluble pollutants in snow covers. The model is based on the liquid water flow, heat transport, and pollutant transport equations....
In-Stream Thermal-Regime Analysis for Powerplant Coolant Dispersion
A steam-tube dispersion model has been adapted to real-time simulation of heat dispersion in a 7-mile reach of the Des Plaines River below Joliet Power Station. Direct feedback control...
Identification Techniques for Bank Erosion and Failure Processes
The Hydraulics Laboratory of the US Army Engineer Waterways Experiment Station (WES) has developed techniques to design small flood-control channels. A component of this research is the...
Failure Modeling of Hydraulic Systems
Techniques of survival analysis are investigated for modeling the failure of hydraulic systems. The Proportional Hazards Model has the advantage of being able to separate the effects on...
Conceptual Evaluation of Dam Safety by Instrumentation
The criteria governing the design of dams can frequently be imprecise. One of the most practical methods of evaluating dam safety in the dam safety surveillance programs is to check the...
Channel Network Analysis Using Simultaneous Solution Algorithm
In this paper, a simultaneous solution algorithm for one dimensional unsteady flow routing through channel networks is introduced. This direct solution algorithm is based on the double...
Scour in Non-Cohesive Beds at Culvert Outlets
An empirical relationship was developed to estimate the depth of scour in non-cohesive material at culvert outlets. The scour depth is expressed as a function of mean particle size of...
Bed Sediments and Bed Forms of the Lower Mississippi River
Approximately 500 bed material samples were collected from the thalweg of the Lower Mississippi River. At each sample location, a sonic record of the bed was obtained. From the appearance...
Bootstrapping Nonlinear Storm Event Models
A bootstrap method for estimating the parameters of nonlinear storm event models is presented. The method pools (combines) the parameter estimates obtained from fitting computed and observed...
Paleoflood Hydrology and Design Decision for High-Risk Projects
Paleoflood hydrology is not merely one of several alternative methods for risk-based design. Rather, certain kinds of accurate data on the largest paleofloods of recent millennia provide...
The Effect of Aeration on Scour
A vertical water jet was used to study the effects of entrained air, tailwater depth, size of bed material, jet diameter, and jet velocity on scour. Small amounts of entrained air were...
Hermite-Galerkin Model for Dam-Break Floods
A model based on the finite element method using cubic Hermite basis functions and Galerkin weighting was formulated to solve the partial differential equations that govern unsteady one-dimensional...
Use of Linear Programming for Hydraulics Problems
Water is becoming a more and more precious commodity worldwide with each passing day. At the same time, the optimum and most productive solutions to water control and utilization are becoming...
Compact Pump Sump Design
This paper details the design criteria chosen to construct a pump sump within several on-site constrictions. The physical size restrictions of the site necessitated the construction of...
The Equivalence of Path and Node Methods for Water Distribution Network Analysis
This paper deals with the equivalence between commonly employed methods, path and node adjustment methods, for analyzing water distribution networks. The basic equations for steady-state...
Return to search