Size Characteristics of Debris Flow Deposition
The size distribution of debris flow deposition is extremely wide which may contain nearly all particles from clay and colloid to boulder. Particle size and composition have very important...
An Approach to the Calculation Method of Mean Sediment Size
Mean sediment size is an important parameter expressing the characteristics of sediment. Several calculation methods of mean sediment size which are popular at present almost have some...
Analysis of Sand Movement on Noto Coast by Geochemical Method
The analysis of sand samples by X - ray fluorescent spectroscopy (abbreviated by XRF) gives the ratio of the geochemical elements to construct the sand samples. This shows the geochemical...
Sediment Transport in Sewers and Design Implications
Extended studies on sediment transport in sewers were conducted at the University of Newcastle upon Tyne and using this new as well as previously available data an attempt has been made...
Costs and Benefits of Meeting the San Francisco Bay Copper Objective by Regulating Small Treatment Plants
Metals in aquatic environments, even in very small amounts, are of concern because of potential toxicity to aquatic life forms. Copper is of particular concern in the San Francisco Bay...
High Level Radioactive Waste Management 1994
The proceedings of the fifth International Conference on High Level Radioactive Waste Management, held on May 22-26, 1994, Las Vegas, Nevada, continues a concerted effort to transfer technology...
Predicted and Measured Behavior of Five Spread Footings on Sand
This publication contains the results of a full scale load testing program used to predict and measure the bahavior of five spread footings on sand. These results were presented at the...
Advances in Cement and Concrete
This proceedings,
Risk-Based Decision Making in Water Resources VI
This proceedings,
Cement Manufacture and Use
This book,
Ground Failures Under Seismic Conditions
This proceedings,
Practical Considerations on the Use of Additives for Shotcrete
Shotcrete is mostly used today for securing rock: in this capacity, it has solved many problems and has become a necessary aid. However, thedegree of utilization of the method is still...
The Influence of Water Glass on the Technological Parameters of Shotcrete
Shotcrete used in tunneling must follow a clearly defined early strength development in order to comply with stresses from rock deformations and drilling and blasting. Accelerators are...
New Advances in Shotcrete Additives: The DELVO System
The DELVO system is a two component, nonchloride chemical system developed to control the dynamics of cement hydration. Concrete, treated with the DELVO system, can be kept in a plastic...
Advances in Dry Shotcrete Technology by Means of Microsilica
During the last decade microsilica has been increasingly used to improve both wet and dry mix shotcrete. In the traditional dry process microsilica is blended in the dry mixture. Since...
An Identity Chart for Steel Fibers
Improvements in ductility and toughness by adding steel fibers to the shotcrete mix are sufficient to enable steel fibers to be used as replacement for steel mesh reinforcements. Steel...
Use of Steel-Fiber Reinforced Wet-Mix Shotcrete in Extreme Rock-Bursting Conditions
If the stresses close to tunnels or caverns exceed the capacity of the surrounding rock, rock-bursting might start. When tunneling in such rock conditions the need for a safe, quick and...
Steel Fiber Reinforced Shotcrete?For Rock Support and Fire Protection
Rapid development in concrete technology and development of equipment has led to a change from dry hand-operated to wet robot shotcreting in Norway. Shotcrete of more than 100 MPa cube...
Steel Fibre Reinforced Wet Shotcrete with Very High Deformation Capacity
Tests have been carried out under site conditions in Norway where the performance of 40 mm long DRAMIX fibres was compared with normally used 30 mm fibres. The fibres were mixed into the...
Tutorial on Computer-Aided Design
These tutorial sessions are designed to provide a basic introduction to the use of Computer-Aided Design/Drafting (CAD) in transportation engineering, with particular regard to Civil Engineering...
Return to search