Wind Performance of Asphalt Roofing Shingles
Pre-seal and post-seal wind resistance of asphalt roofing shingles is discussed. A test method for evaluating pre-seal wind damage is described. Wind tunnel testing results are presented...
Ballasted Single Ply Design Guide Development
A new roofing concept called ballasted single ply has now captured about 25% of the new and retrofit flat roof market. This concept relies on the use of ballast to provide the wind resistance...
Seismic Response of Multistory Building Structures With Flexible Floor Diaphragms
An efficient model for three-dimensional analysis of multistory structures with flexible floor diaphragms is proposed in this paper. Three-dimensional analysis of a building structure...
Floor Response Spectra Including Structure-Equipment Interaction Effects
An efficient method for generating floor response spectra with the structure-equipment interaction effects is proposed. Floor response spectra are computed from a prescribed ground response...
Wind Resistant Design Manual for Highway Bridges
The new wind resistant design manual for highway bridges has been required recently in Japan. The working group was organized in the Japan Road Association is 1984 to prepare the manual....
Status of Structural Engineering Research
Problems and opportunities for structural engineering research are being addressed in a study by the ASCE Structural Division Task Committee on Structural Engineering Research Needs/Funding....
LRFD: Progress for Engineers and the Wood Industry
The LRFD for Wood project represents a milestone for the industry. The significance of the project goes far beyond merely switching formats in design equations. The project signifies both...
Current Bridge Research at Iowa State University
For the past 20 years the majority of the structural engineering faculty in the Department of Civil and Construction Engineering at Iowa State University (ISU) have performed research...
Development of Skewed Element for the Concrete Pavements
In the recent years, highway engineers introduced skewed joints in the concrete pavement with a 4 foot to 5 foot skew on a 24 foot width pavement, which results in only one wheel crossing...
An Education in Tunneling
In this follow-up to the author's article in the April 1989 issue of Civil Engineering, this senior civil engineer and winner of the 1988 Martin Kapp Foundation Engineering...
Fast Tracking Military Waste
The installation restoration program, the military version of Superfund, helped fast track the cleanup contracts for four military hazwaste sites located at Hanscom Air Field, Bedford,...
Hydrogeology Comes to the Surface
Before concluding whether groundwater is safe or contaminated, engineers must understand the science of hydrogeology. If they don't understand hydrogeology, unnecessary and...
Dynamic Response Prediction for Earthquake Resistance Design of Bridge Structures
Newly developed nonlinear analysis procedures for assessing the earthquake resistance of bridges have been incorporated into the computer program SEISAB (SEISmic Analysis of Bridges)....
Experimental Evaluation of Performance of Earthquake Restrainers in Box Girder Bridges
Type C-1 restrainers were used in most of the concrete T- and box girder bridges which have been retrofit. Type C-1 restrainers consist of 7-3/4 in. diam. galvanized cables, bearing plates,...
Vertical Response Data from the Dominion Road Bridge Test
In January and February of 1985, two bridges were tested in New Zealand using simulated earthquake loads. The objective was to determine the in-situ seismic response of two reinforced...
Rapid Visual Screening of Buildings for Potential Seismic Hazards
A Rapid Screening Procedure (RSP) developed for use nation-wide is based on a 'sidewalk survey' of a building, in which a Data Collection Form is completed by...
Experimental Study on Structural Control for Seismic Loads Using Passive and Active Devices
The feasibility of controlling the responses of structures against seismic loads is investigated through some experiments and numerical analyses for both the passive and active control...
ATC-23: A Survey of California Hospitals for Earthquake Survivability Potential
In September, 1986 the SSC recommended the completion of a survey of existing acute care hospitals as the first step in a program to bring about the upgrading of all pre-1973 hospitals...
ATC 14: A Methodology for the Seismic Evaluation of Existing Buildings
A new method for evaluating the seismic resistance of existing buildings has been developed based on the historic performance of buildings in past major earthquakes. This methodology identifies...
Postearthquake Safety Evaluation of Buildings
Procedures for the safety evaluation of buildings in earthquake damaged areas have been developed. Two evaluation techniques, Rapid Screening and Detailed Inspection, are described. Rapid...
Return to search