A 250 KW Closed Cycle Land Based Ocean Thermal Energy Plant
The paper describes the design of a 250 KW land based closed cycle Ocean Thermal Energy Plant suitable for installing at Keahole Point in Hawaii. The work is being done for ALCAN International....
Overview: Steam-Water Phase Change in OTEC Systems
This paper presents an overview of the thermodynamics and the heat and mass transfer processes occurring in OTEC systems utilizing seawater as the working fluid....
Seawater Experimental Results of Direct-Contact Condensation for OC-OTEC Applications
Tests of a direct-contact condenser (DCC) for open-cycle ocean thermal energy conversion systems (OC-OTEC) have been conducted using seawater and exchanging up to 1.25 MWth...
Noncondensable Gas Composition and Outgassing Rates in the Open-Cycle OTEC System with Direct-Contact Condensation
This paper will present the results of recent measurements of noncondensable release from an open-cycle ocean thermal energy conversion (OC-OTEC) system in a direct-contact condensation...
De-Aeration and Re-Injection of Noncondensable Gases in Open-Cycle OTEC
Non-condensable gas exchange characteristics in seawater and fresh water are compared and contrasted. The higher rate of exchange observed for these gases in seawater is incorporated in...
Carbon Dioxide Release from OTEC Cycles
This paper presents the results of recent measurements of CO2 release from an open-cycle ocean thermal energy conversion (OC-OTEC) experiment. Based...
Large Stone Hot Mix Asphalt: State of the Art
Improved mix characteristics can be achieved by utilizing existing well-known technologies. Developments have included: more attention to voids in mineral aggregate criteria; adjusting...
Improved Prediction of Masonry Durability Through Advanced Materials Science Methods
Several trends in the use of materials in civil engineering have made it imperative to improve the ability to predict the durability of masonry. This will require more emphasis on materials...
Premature Failures of Outdoor Masonry Pavements
The authors have investigated and repaired a number of premature inservice failures of masonry paving systems in recent years. These systems have become common, built over underground...
Performance of Latex-Modified Thin-Set Mortars in Applications of Thin-Brick Veneer
The use of field-applied polymer-modified mortars for adhering thin brick or tile to building exteriors has become increasingly common in the last decade. The latex-modified mortars can...
Are ASTM Standards Enough?
ASTM (American Society for Testing and Materials) is most likely the World's most renown developer of voluntary consensus standards. Its standards development process utilizes...
Three Tools for Design Test Bed Analysis
Three analytical tools are outlined for use in design test bed work focusing on the design/production interface. The tools are substitution analysis, coupling analysis, and value chain...
Montana's Approach to Reduce Asphalt Pavement Rutting
The Montana Department of Highways experienced premature rutting in some asphalt concrete pavements primarily on the east-west interstate in Eastern Montana. Montana participated with...
Concrete Pavement?Specification by Modeling
Concrete pavement specifications have traditionally been prescriptive with construction in-put defined. This practice does not include a definition of the product intended, restricts innovation,...
Accurate Computation of Freezing Index
'Freezing index' (cumulative degree-days below freezing) is used for predicting frost penetration depths and modelling pavement performance. Contour maps which illustrate geographic trends...
ASCE Salary Survey 1989
The 20th biennial ASCE salary survey of the engineering profession conducted by the ASCE Committee on Employment Conditions during the fourth quarter of 1989 is presented. It consists...
More Than a Public Hearing
Too often, required community input is reduced to the sometimes dreaded public hearing. Many formal public-involvement programs are comprised of no more than this minimal, yet essential,...
Commuting Computing
Portable computers come in many different shapes and sizes and boast many of the same features as desktop machines. Unlike desktop PCs, however, the key to getting the most use out of...
Project Management: Now On-Line
Only 20 years ago, computerized project management was available only to large firms with mainframe computers. Even four or five years back, well into the personal-computer revolution,...
Prospects for International Engineering Practice
International trade is growing in construction products and services. It is stimulated by international efforts to reduce technical barriers to trade and the formation of a single European...
Return to search