The Transport of Crude Oil Under Saline Ice
A mathematical model was developed to describe the forces acting on an oil slick under saline ice in the presence of a water current. The model was verified through a set of laboratory...
Moisture Effects on Extruded Polystyrene Insulation
The amount of moisture within the insulation was determined by carefully weighing each sample and then measuring its volume. Two methods of measuring thermal conductivity were used. The...
The Evolution of a Factory Insulated Piping System
This paper reviews the developments over the past fifteen years in a factory insulated high density polyethylene piping system that has become a standard for sewage and water piping systems...
Insulation Performance Beneath Roads and Airfields in Alaska
Evaluations of the long-term thermal performance of installations in Alaska for frost heave control have included sampling and testing of the insulations to determine the retained thickness,...
Sheet Pile Interlock Behavior: A Moving Contract Problem
The finite element method is used to analyze the behavior of sheet pile interlocks subjected to an uniaxial pull test. The thumb and finger of the interlock provide three contact points...
Optimal Design of Continuous Prestressed Concrete Girders
Design of continuous prestressed concrete girders with possibility of parabolically varying depth in each span is formulated in the form of a mathematical programming problem. The design...
Finite Element Discretization for Mixed-Mode Fracture Problems
The finite element discretization of mixed-mode problems in fracture mechanics is investigated. The characteristics of the mesh near the crack affect the accuracy of the finite element...
Strengthening Alaskan Beaufort Sea Soils with Portland Cement
Preliminary studies undertaken to assess the feasibility of utilizing gravity structures on soft arctic silts indicate that the available foundation capacity are insufficient. Therefore...
Failure Investigations for Forensic Engineering
Failure investigations related to construction Industry is described in detail in the article. A failure investigation is one of the most demanding of engineering undertakings. It requires...
Large Mat Foundation Analysis on Expansive Soil
This paper describes a comparison of predicted and observed performance of mat foundations on stiff expansive soil. Foundation performance was predicted using a new computer program BOSEF...
Attaching Steel Members to Reinforced Concrete Elements
A variety of structural systems have been devised to strengthen existing buildings for improved seismic resistance. Strengthening methods currently in use for reinforced concrete structures...
The Asbestos Impasse
Removing asbestos from the nation's buildings is a major task . Consulting engineers can play an important part in the process, locating and quantifying the carcinogenic material,...
Attapulgite: A Clay Liner Solution?
Poor performance of clay liners at waste management facilities has resulted in the EPA mandate of synthetic polymeric liner materials to comply with zero penetration requirements. Laboratory...
U.S.-Japan Coordinated Program on Masonry Research
An overview of the U. S. -Japan Coordinated Program on Masonry Research is presented. The program consists of parallel efforts in Japan and the United States to develop design methods...
Dynamics of 3-D Base Isolated Structures
The work described in this paper concerns the dynamic behavior of asymmetric base isolation systems consisting of laminated rubber bearings and hysteretic dampers. It is shown in this...
Flexural Behavior of Reinforced Masonry Walls and Beams
Many reinforced masonry walls and beams were tested as a part of the U. S. -Japan cooperative research program on masonry building structures. Six concrete block and two clay brick masonry...
Stress-Strain Behavior of Grouted Hollow Unit Masonry
Experimental results from axial stress-strain tests including post-peak response on hollow unit masonry prisms are compared to those of previous researchers....
Engineering Laboratories' Role in Quality
Quality construction of a quality design is one goal which Owners, Design Professionals, and Contractors can all agree is needed if the project is to be truly successful. The Engineering...
Development of Second Generation Plasticized Sulfur Binders as a Paving Material
Plasticized sulphur is produced when melted sulphur is reacted with selected hydrocarbons to produce polysulfides. These polysulfides help retain a 'polymeric'...
Large Scale Testing Facility for the Evaluation of Structural Systems Under Critical Loads
The Charles Lee Powell Structural Systems Laboratory at the University of California, San Diego, provides, with a 50 ft. high reaction strong wall and a 120 multiplied by 50 ft. box girder...
Return to search