Driven Then Pushed Minicone Tests in a Sand Chamber
For a general knowledge on the Standard Cone Penetrometer test and its uses the reader is referred to the work of Briaud and Miran (1991). For this study (Khalaf and Briaud, 1992) a smaller...

Lateral Loading Curves from Pressuremeter Tests
The large drilled shafts for the proposed Klamath Falls Bridge, which are to be founded in diatomaceous silts, were to be designed to withstand earthquake induced large cyclic loading....

Piles for Marquette University Math Building
This paper presents a comparison of static pile capacity predictions using CPT cone resistance results with results of a test pile program and production pile driving. Pile capacity prediction...

Evaluation and Monitoring of Pile Performance Using Dynamic Measurements in Supporting Offshore Structures
The installation of offshore platforms into deeper waters and new environments is accompanied by an increasing uncertainty in the structure response, foundation design and performance....

Execution and Evaluation of High Capacity Caisson Load Tests in Glacial Deposits
As part of the Boston Harbor clean up project, the new 1,000 mgd Deer Island Sewerage treatment plant includes ten 240 feet high egg-shaped 'residuals' tanks. Contract documents called...

Bi-Directional Load Testing of Shafts to 6000 Tons
This paper describes the use of Osterberg cells (O-cells) to perform bi-directional load testing on full size production drilled shafts for a major bridge foundation near Owensboro, Kentucky....

Load Testing of Permanently Cased Drilled Shafts Founded in Hartford Shale
The axial and lateral load testing of three, 30 inch (76cm) diameter, permanently cased drilled shafts is analyzed herein. The prototype shafts were founded in (or on) Hartford Shale bedrock,...

Perimeter Load Transfer in Drilled Shafts in the Eagle Ford Formation
Results of six full-scale compression loading tests at four sites in the Dallas area are considered. Compressive strengths (qc) of the rock varied...

Side Resistance of Drilled Shafts in the Denver and Pierre Formations
Results of load tests on drilled shaft foundations in Upper Cretaceous shales are described and evaluated. Three load tests were conducted on shafts in the Denver Formation, in Denver,...

Negative Skin Friction Due to Wetting of Unsaturated Soil
A steel building at a cement plant un Utah was originally supported by spread footings. Shallow wetting of the coarse granular soils supporting the footings resulted in over three inches...

HUD Concerns: Post-Tensioned Foundations in Texas
An investigation was conducted of post-tensioned slab foundation systems in Texas pursuant to a request from the Headquarters Office's of the U.S. Department of Housing and Urban Development...

Airport Pavement Innovations?Theory to Practice
This proceedings, Airport Pavement Innovations?Theory to Practice, consists of papers presented at the ASCE Specialty Conference held in Vicksburg,...

Innovation in Repair Techniques of Concrete Structures
Since the infrastructure constitutes the economic base for production and consumption, its condition is a critical determinant of the economic viability of the United States. At the present...

Utilization of Industrial By-Products for Construction Materials
The United States is a major producer of agricultural, industrial, mining, and municipal waste materials in the world. Traditional methods of waste disposal most often have resorted to...

Waterpower '93
This proceedings contains the papers presented at the Waterpower '93 conference held in Nashville, Tennessee, August 10-13, 1993. The conference brought together owners, planners,...

Compendium of Pumped Storage Plants in the United States
The Compendium of Pumped Storage Plants in the United States was prepared by the Pumped Storage Task Committee of the Hydropower Committee...

Ups and Downs in Chicago
The Chicago Title and Trust Center�a 50-story mixed-use complex which opened late last year�offers 1.3 million sq ft of above-grade space, and three levels of below-grade parking. The...

High Performance Construction Materials and Systems
An Essential Program for America and Its Infrastructure?Technical Report
This report, High Performance Construction Materials and Systems: An Essential Program for America and Its Infrastructure - Technical Report...

U.S. Experience With Armor-Stone Quality and Performance
In the past 30 years problems with deterioration and cracking of armor stone in the United States have been concentrated in northern regions, particularly around the Great Lakes. The explanation...

Service Records of Chicago District Breakwater Stone and How These Relate to Test Results
Breakwater stone production is limited to areas with geologic outcrops capable of producing large rocks. The most reliable breakwater stone is that which exhibits the highest degree of...

 

 

 

 

Return to search