A Structural Analysis Model for Timber Shear Walls
A numerical modelling procedure for the non-linear analysis of timber shear walls is presented. The model includes the non-linear behavior of the connectors between the sheathing and framing,...
Analysis of Slender Prestressed Concrete Columns
This paper briefly describes an analytical model developed to study slenderness effects in prestressed concrete columns and walls and predict the characteristics of such members over a...
Reliability-Based Design of Transmission Line Structures
Reliability-Based Design (RBD) is an emerging concept for the design of transmission line structures and holds the potential to reduce the cost of lines or increase their reliability....
Overview of Programs at Sandia National Laboratories
This paper presents on overview of the containment integrity programs at Sandia National Laboratories. Companion papers at this conference give greater details about the construction,...
Containment Model ? Test Program and Results
Sandia National Laboratories (Sandia) completed the testing of a 1:6-scale containment building for a Light Water Reactor (LWR) in July 1987. The containment building was made of reinforced...
Development of a Test Validated Methodology for Predicting Concrete Containment Leakage
In the past several years, considerable research effort has been devoted by the Electric Power Research Institute and the U.S. Nuclear Regulatory Commission to the behavior of reactor...
Strength Evaluation of Existing Reinforced Concrete Structures
The load test as described in ACI 318-83 Chapter 20, entitled 'Strength Evaluation of Existing Structures,' was conducted at 60%, 80%, and 100% of the calculated...
Fourier Series Expansion on Determination of Response Bound of Beam
Fourier series expansion is suggested to discrete the continuous vibrating system by regarding Fourier constants as generalized displacement parameters. The orthogonal merit to the terms...
Aerodynamic Modeling of Chimneys
The wake induced acrosswind behavior of circular cross-section structures, such as industrial chimney, has been studied for many years using wind tunnel models. Due to the relaxation of...
Mitigation of Wind-Induced Vibration of Tall Buildings
This paper summarizes a detailed study of the sensitivity of building acceleration to changes in structural stiffness, mass and damping and to the eccentricities in the centers of stiffness...
Aerodynamic Methods for Mitigating Wind-Induced Building Motions
Excessive wind-induced motions of tall buildings most frequently result from vortex shedding induced across-wind oscillations. This form of excitation is most pronounced for relatively...
Wind Performance of Asphalt Roofing Shingles
Pre-seal and post-seal wind resistance of asphalt roofing shingles is discussed. A test method for evaluating pre-seal wind damage is described. Wind tunnel testing results are presented...
Floor Response Spectra Including Structure-Equipment Interaction Effects
An efficient method for generating floor response spectra with the structure-equipment interaction effects is proposed. Floor response spectra are computed from a prescribed ground response...
A New Proposal of Design Wind Loads for Beams Supporting Long-Span Roofs
The wind tunnel testings of wind pressures acting on long-span roofs are carried out. Dynamic wind pressures are measured simultaneously at a lot of points on the roofs. The instantaneous...
Field Observation of Aerodynamic Responses of a PC Cable-Stayed Bridge During Its Erection
Recordings were made of the response of a PC cable-stayed bridge during erection and the wind velocity at erection site. These recordings were analyzed to provide estimates of the characteristics...
Wind Resistant Design Manual for Highway Bridges
The new wind resistant design manual for highway bridges has been required recently in Japan. The working group was organized in the Japan Road Association is 1984 to prepare the manual....
Codification of Wind Effects for a Long Span Suspension Bridge
Construction of the Akashi Kaikyo Bridge, which will cross the Akashi Kaikyo Straits with a shore-to-shore of approximately 4 km, started in spring of 1988. Firstly discussions on the...
Bridge Loading Evaluation for Limit States Design in Japan
Some statistics regarding bridges in Japan are firstly explained. Next, the limit states design which will be introduced in 1995 for highway bridge design specification in Japan is briefly...
Fatigue Life Evaluation of Welded Structural Details in Steel Highway Bridge
Stresses in highway bridge members, fatigue crack propagation behavior and long life fatigue strength properties of welded members under traffic loadings and prediction of fatigue life...
Evaluation of Bridge Safety and Remaining Life
In developed countries, the emphasis on the infrastructure is changing from new construction to the safe maintenance of existing structures. Highway bridges represent an excellent example...
Return to search