ASCE will be sunsetting the Civil Engineering Database (CEDB) in the coming months. We encourage you to start using the ASCE Library to perform content searches. In the ASCE Library, you can save your search results as well as receive email content alerts when new content relevant to your area of interest is published. Try it out today at https://ascelibrary.org.

 

Evaluation and Surveillance of Concrete Bridge Structures
A number of cost-effective techniques are available for evaluation and surveillance of concrete bridge structures. The methods covered in this paper include: long-term bridge instrumentation,...

The Behavior of R/C Pinned Bridge Columns under Lateral Loading
Four one-eighth scale one-way hinge details of the type used in highway bridges were tested to study the effect of combined shear and flexure caused by lateral loads. The aspect ratio...

Wind Tunnel Investigation of a Twin Deck Suspension Bridge
Wind tunnel measurements of the response of a twin deck suspension bridge to dynamic wind loads are presented. The investigation was concerned with the determination of the deck response...

Safety of Long Span Highway Bridges Based on Dynamic Response
This paper consists of an analytical study regarding the dynamic response of highway bridges subjected to heavy vehicle loads, with emphasis on long span low fundamental frequency bridges....

Kinematic, Diffusion and Dynamic Catchment Modeling
This paper reports on a series of tests aimed at developing improved procedures for catchment routing. The objective is to compare kinematic and diffusion models within several scenarios...

Utility Programs for DWOPER and DAMBRK
Time and computer resources greatly limit potential investigations and sensitivity anslyses. In order to facilitate modeling with the National Weather Service (NWS) programs DWOPER (Operational...

Criteria for Selecting a Reservoir Routing Method
Results of an investigation comparing dynamic and storage reservoir routing applied in dam safety analyses are presented. Outflow hydrographs computed by these reservoir routing methods...

A Modal Coupling Procedure for Structural Dynamics
A method is presented for synthesizing the real modes of substructures to obtain the complex modes of the combined structure. These complex modes properly include the nonclassical damping...

A Comparative Study of Different Base Isolators
A comparative study of the effectiveness of four different base isolators is carried out. The structure is modeled as a rigid mass and the accelerograms of the North-South component of...

Response of Structures to Horizontal-Vertical Earthquakes
In the present work, the responses of a class of hysteretically nonlinear structures subjected to the combined horizontal and vertical random ground accelerations are studied. A massless...

Seismic Response of Simple Structures with Coulomb Damping
A single story structure incorporating a floor-sliding mechanism for dissipation of vibration energy through Coulomb friction damping is examined. The response of this structure is evaluated...

Cracking of a Tilt-Up Structure Due to Dynamic Loads
The extensive cracking of a tilt-up reinforced concrete structure is discussed. The site investigation revealed horizontal cracks at two feet to seven feet above a mezzanine level which...

Nonlinear Axisymmetric Uplift of Circular Plates
A formulation of a method of analysis of the nonlinear axisymmetric response of the bottom plate of a liquid storage tank under uplifting forces is presented. At first, the plate is assumed...

Dynamic Behavior of R/C Buildings in Vi? del Mar, Chile
The Chilean earthquake of 3 March 1985 resulted in an effective peak acceleration of 0. 36g in the coastal city of Vina del Mar. The city had an inventory of over 400 reinforced concrete...

Methods for Improving the Seismic Response of Concentrically Braced Steel Frames
This paper briefly reviews various factors contributing to the poor performance occasionally observed in concentrically braced steel frame structures during recent earthquakes. Several...

Unusual Shaped Highrise Buildings in Seismic Zone
The structural concepts, seismic analysis and design of five recent highrise structures are presented in this paper. The paper deals with the problem of multistory buildings having 'structural...

The Design and Construction of the Washington State Convention and Trade Center Over Interstate 5
The Washington State Convention and Trade Center is a 10-level, 1,000,000-square foot facility constructed over Interstate 5 in downtown Seattle. The project spans over three city streets...

Serviceability Limit States in Load Space
Deflection and elastic limit state curves are drawn in load space using a nonlinear structural analysis program. Use of load space simplifies computation of point estimates of serviceability...

Application of Normal Integration Formulas to Bridge Reliability Analysis
Structural reliability analysis often involves extensive integration of complex multivariable functions. Special techniques can be used to reduce this numerical effort. This paper deals...

Applications of Fiber Bundle Model to Structural Engineering
The bundle failure time has been studied extensively for both deterministic and random loads. The objective of this paper is to apply results in these studies to the dynamic analysis of...

 

 

 

 

Return to search