Cyclic Degradation of Pile Performance in Calcareous Soils
Laboratory data on the skin friction of jacked or driven model piles is presented. Significant cyclic degradation of skin friction commences when the cyclic displacement amplitude reaches...
Residual Stresses in Piles and the Wave Equation
A data base of 18 vertical load tests on driven piles in sand is presented. On average the residual point load was 56% of the measured point load and the residual friction load 19% of...
Compression Load Tests on Concrete Piles in Alluvium
A series of tests was accomplished during the design phase for the West Seattle Freeway Bridge Replacement project. The results of instrumented compression load tests in alluvial deposits...
Vertical Behavior of Two 16-Year Old Drilled Shafts
Vertical load tests were performed on drilled shafts subject to lateral confining and heaving pressures from expansive soil over 16 years. Results indicated mobilized skin friction equal...
Evaluation of P-Y Relationships in Cohesionless Soils
Four semi-empirical procedures for construction of p-y curves in cohesionless soils were developed to fit data from a particular load test or a specific set of tests on similar soils....
Evaluation of P-Y Relationships in Cohesive Soils
The practice of analyzing laterally loaded driven and bored piles often requires modeling of soil response in terms of uncoupled, non-linear unit load transfer functions. These functions,...
Lateral Load Tests of Piles in Sloping Rock Fill
A new container wharf constructed at the Port of Los Angeles features vertical prestressed concrete piles to provide both vertical and lateral support. A rockfill embankment used to allow...
Pile Caps Subjected to Lateral Loads
This paper reviews current pile cap design practices and presents results of tests on two pile caps with different reinforcement locations. Lateral load tests performed on two pile cap...
Winkler Soil Model for Axial Response Analysis of Pile Groups
In this approach, the soil is idealized as a nonlinear Winkler model for a pile group attached to a group of piles. The model can account for pile-soil-pile interaction. Pile group responses...
A Structural Engineering Perspective for Drilled Shafts
This commentary is an attempt to close the gap between the Building Code Requirements for Reinforced Concrete (ACE 318-83) and the design of drilled shafts. The context of design includes...
ASCE Drilled Shaft Standard: University Perspective
A critique is presented of the proposed ASCE standard on drilled shafts. Areas where major work is necessary relate primarily to the shaft design sections, establishment of loads, and...
Selecting an Economical Water Main Rehab
Many miles of aging water mains exist with carrying capacities that are less than half of what they were when new. Engineers must, therefore, stretch every dollar to eliminate deposits...
Abrasion Resistance of Polyethylene Dredge Pipe
In recent years there has been a slow but steady increase in the number of dredges using high density polyethylene (HDPE) pipe in discharge lines. HDPE's increased popularity...
Effects of Fines in Gravel Bed Streams Behavior
A model-gravel bed stream is studied in the laboratory. Flow visualization of bedload motion correlates with bursting phenomena near the bed. The bedload variation as a result of the addition...
Movement of Tractive Sediment from Disturbed Lands
The Smoky Creek basin of the coal area of northeastern Tennessee shows extensive evidence of tractive movement of coarse sediment from mined tributary basins into the main channel. Coal-rich...
River Basin Management: Role of Hydraulics and Hydrology
One of the major Illinois rivers originates in a neighboring state. The main stem of the river was channelized about 65 years ago, and is considered to be a 'drainage ditch....
Optimal Real-Time Operation of a Cascade of Hydropower Plants in Central West China
The Longxihe River hydropower system consists of four hydropower plants in series. The four reservoirs are used for flood control and power generation. Among the four reservoirs, only...
Plastic and Other Limit State Methods for Design Evaluation
These proceedings consist of seven papers dealing with the topic of the design of complex structures using limit state methods. The emphasis is on the role of plastic or limit load techniques....
Structural Engineering in Nuclear Facilities
The papers in this publication cover the general theme of civil and structural engineering as they are applied to nuclear facilities. Traditional topics include seismic analysis, impactive...
Guidelines for Transmission Line Structural Loading
Procedures are provided for the selection of design loads and load factors based on the latest research and state-of-the-art design techniques. This selection has an effort on the reliability...
Return to search